oil sending unit or disconnect the harness from the sending unit to test to see if the sending unit is bad. Try both unless you know the switch is normally open or normally closed. Replace the sending
...oil sending unit or oil level low or dirty oil (some generators have a fuel cut-out solenoid at the carb ). Key switch will override the low oil safety. Easy test, remove wire from oil sending unit. ...
Question about Generac Power Systems Electrical Supplies
...change the oil after the first 5 hours of use. All it does is backfire once and a while but won't start. I turn the switch to on, turn the gas valve, and close the choke with no luck. I also try ...
...oil is full and overflowing per the instructions, gas is fresh but it doesn't appear to be getting gas. I removed the air filter and sprayed in starter fluid which got the unit to turn over but once ...
...oil level sensor (sending uint) may be the culprit causing your problem. Item 2 this link: ...
...change the oil or low oil. If still no spark, leave the sending unit wire unplugged and remove the boot from the plug wire. Insert a short piece of paper clip wire into the end of the plug wire and ...
1 questions posted
Usually answered in minutes!
2 Questions
1 Questions
