Question about Coleman Electrical Supplies
...jet) is clean. run the engine up no load screw it out untill the engine runs rich then slowly turn it back in untill it clears..then load it and do the same. the arm is the govenor trying to play ...
...clean the high speed jet. if i was you once i had it apart i would go ahead and clean the entire carb. generators are bad about doing this because they get used so sparatically Well sticking float is ...
Question about Honda Electrical Supplies
...clean the main jet and nozzle first shut fuel off,remove the bottom bolt of fuel bowl and pull away,inside the stem where bolt came out of are the jet and nozzle using a #2 screwdriver insert in the ...
...only start with gas shot into carb.starts then dies. Should be an inline fuel filter make sure you change it also. Try again to clean the low speed jet...you must see clear through the ...
Question about Honda Electrical Supplies
jet to clean. Starts with fluid, but stops. Float is working Main jet on carb is clogged. Starts when you prime but then will shut off. Remove and disassemble carb taking pains to thoroughly clean the
...be great. Check air filter is clean. Check the governor linkages are moving ok. The carburettor jets may have become coated with deposits of gum over time, reducing the fuel flow and weakening
...steam The steam jet ports (small nozzles / jets) collected mineral over time. You will need CLR mineral remover to clean the jets. See video below for more info. ...
...run , is to pour gas into carberator and full choke it has a blocked fule line and maybe blocked jets in the carb first clean all the fule lines from the tank down check the filter in the tank as ...
...jet is clean along with the holes in the side of the jet. (daylight check of pin hole) Usually on the bottom of the gas tank there is a fuel bowl. Remove the bowl and dump contents making sure it is ...
Question about Coleman Electrical Supplies
...generator will start but won't continue to run Remove Carb and clean and soak then blow out the jets. This is a common problem as they tend to set up with old fuel in them and when you want to ...
24 questions posted
Usually answered in minutes!
1 Questions