...boiler in an other room and full is way to heavy. Turn main water off to the water heater, it may be a valve on cold side coming in to shut off. Next turn power off to the heater and drain the tank ...
Question about Water Water Heaters
cold water entering---the AQS senses the temp change and turn on the boiler to heat up (fire) for the hot water demand--- if this doesn't do this the AQS is faulty or needs readjustment----now another
Question about Water Heaters
...comes hot when the tap is on the boiler doesnt ignite to give any hot water Is this a new problem? Is it just running the cold out of the pipes before the hot water shows up? Is it a on demand or ...
Question about Water Heaters
...boiler is) the bathroom or having a shower, the water has started to get cold after a few seconds of running and then heats up again, but by the time the water has started to come through the ...
boiler needs pressurising firstly connect hose hand tight open the non return valve normally teed into a 22mm pipe then flick the valve lever on the cold supply quick little bursts till you reach your
Question about Amtrol Water Heaters
...cold you have very little boiler water going through the loop. Make sure the isolation valves on the loop are open. Is your boiler full of water? If the boiler loop lines are hot going in and coming ...
Question about Water Heaters
...boiler. There does appear to be a small amount of hot water that comes out the tap eventually after a long run but I have to keep tap turned down really low so its not full on. Oh some of these there ...
Question about Water Water Heaters
...comes on is this ok. Boiler is an alpha he cb33, have tried to locate drain point from diagram but can't see it. Could we drain water from a radiator to get the pressure down. You need to check with ...
...boiler and both my upstairs basin taps have very high pressure. I have turned the inlet pipe down to mimimum but now the hot tap will not turn on or off slowly. it seems to 'pop' on full or off with ...
Question about Water Heaters
...Boiler running 8 rads and towel rail. System pressurised to 1.2 bar cold. System power flushed and in-line magnetic filter fitted. Superb installation. It just takes forever to to rads to get up to ...
49 questions posted
Usually answered in minutes!
335 Questions
250 Questions
267 Questions
222 Questions
190 Questions