I have a 2001 kawasaki zx9 and I want to if when the bike is running if both sides of the tail light should light up with the running light and then when the brake is pushed if one side should go out and the other side should get bright. I am under the impression this is the way these bike are from the factory but im having trouble passing inspection because of that. Thanks jeff

ZXR 750 alternator belt change - ZX Forums

www.zxforums.com/.../zx-7r.../37625-zxr-750-alternator-belt-change.ht...Jun 3, 2010 - Hey there is no belt the bike just had a seperate alternator like the early zx9's and it fits the engine and is driven by a gear off the crankshaft so ... Alternator belt adjustment on 1989 zx7 - ZX Forums
Apr 28, 2015
H-model alternator belt adjusting. - ZX Forums
Sep 21, 2012
89 zx-7 Engine Options - ZX Forums
Feb 29, 2012
1990 zx750r - ZX Forums
Oct 11, 2011
More results from www.zxforums.com

kawasaki diagram replacing alternator belt Questions ...

www.fixya.com/tags/diagram_replacing_alternator_belt/browse/kawasaki

kawasaki diagram replacing alternator belt related problems. ... ZXR750 H1/H2 - need above to find if bike has rectifier/regulator, to run continuity test on it, ..

Hi,what I used to do in the past is swich of the petrol undo all the screws on the bolls of the carbs and get a low pressure air line and put it on the line that the petrol gose into the carbs and just give it a few kwick blasts,I had a bike that I was always running out of petrol due to gage not working,always worked for me,(just to say that if you asked a bike macanic he would proberly not advice it)the only other option is to take the carbs off the bike and clean them,all the best

that is where the vacuum line goes

If it's like my 2003 ZX9, to take the riders seat off you open the rear compartment by removing the passenger seat, the front bracket that hold the the seat has two 8mm bolts and a screw. Unscrew the screw and remove the bolts and slide or remove the bracket and then the riders seat lifts up.

Check with Color Rite they do all the factory paint codes.

Color Rite

No... the 94 bike is a different design, also the frame is a complete new design on the 98

You cannot just wire up a turn signal to operate on the tail/brake lights without using a device called an integrator. Otherwise it is not possible to separate the functions.
If you look on EBay or seach the internet under 'turn signal integrator' you should be able to find these devices.
The kit should ocme with specific wiring intructions.

let it dry out and kick it over a few times with the plug out. it should start fine when dry.

You're looking for part number 27002A. In this picture it is found very close to the horn. That does not mean is is close to the horn on your bike, but I would check there first if it is easy to get to. Usually there is an electrical box. The fuse box may contain the relay. Your dealer should be able to tell you exactly where it is, as would any shop manual for your bike.