I would like to fit a BMW 1200 GS Adventure tank to a standard GS, what should be on the look out for. Are there any diagrams or books on this.
SOURCE: Clutch problem
check the level of the clutch fluid in your resevoir, maybe a slow leak that is allowing the chutch to release. When was the last time the fluid was changed?
SOURCE: Shattered side stand safetly switch 2008 BMW Adventure
Take the 2 wires and connect them together. Either by a **** connector or twisting them together and electrical taping them in place.
I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb
SOURCE: I have a 1200 GS Adventure 2006 model, with no
Sounds like either a connector that serves the instruments, or a fuse. I would suspect a connector first off.
SOURCE: 2008 bmw gs adventure manual
on the net go to,,,,www.maxbmwmotorcycles.com
there all on there,,,,,trust me on this one!
SOURCE: How do I replace the clutch of my 2007 1200 GS
Is your clutch slipping?? Is there an oil leak between the engine/trans?
Replacing the clutch on a R1200GS is a bit involved unless you are very mechanically skilled. You basically split the bike in half to remove the transmission and gain access to the clutch. You need a means of supporting the front half of the bike under the engine while you remove the back half of the bike. Disconnect electrical harness from the rear, disconnect brake lines to the rear of the bike. remove throttle bodies etc. takes 2-3 hours for a skilled mechanic to get the clutch out, then 4-6 hours to put all back together again CORRECTLY!
If the clutch is NOT slipping, I would suggest removal of the starter motor on the lower LHS of the engine/ trans. and measurement of the clutch disc before you start the work of disassembly
374 views
Usually answered in minutes!
×