Cuts out when rideing

Check your fuses, the big ones. They go bad often i always carry two spares.

Need clutch adjustment

hi my bakkie do not whant to go into any gear. if i press the cluth pedal to put it into gear it look like the engin press up into the air

rivet could be loose in cluth basket

check gas cap vent
clean it out then try it again

Check to see if you left the blades engaged. There is a safety switch that prevents starting with blades engaged. Easy to miss, happened to a friend of mine last month.

If this really helpful, please rate.

This sounds like fuel flow based issue, have you checked the fuel screens for restrictions?

thats a fule shut dowen on the carb what is doing or not doing

Check to make sure that the inline fuze is not blown on your switch to your deck. also make sure that the belt is free moving and not binding

i going to assume that yr tractor does have the hydrolic p.t.o. that controls the drive and cutting mechanism's???... if so you might start with checking the hydrolic fluid in the resevior. or you might check into replacing the hydrolic p.t.o. pump , if you ran the tractor in heavy work without any hydrolic fluid in the p.t.o. pump the pump is probably burnt up. if so im sure you can beat the cost of a new pump by rebuilding it yrself with a kit.