Speedometer won't work, tried changing the cable and gauge still nothing..any suggestions

Speedometer cable maybe twisted or ready to brake

you will have to check to see if the connection is a cable or electronic sensor. If it is a cable loosen the end by the transmission and check to see if it is broken or if the end is stripped if so replace the cable. If it is a sensor you might have to change the speed sensor. good luck

Just pull out the 10amp cluster fuse and put it back in. The cluster will pop right back up. My 2004 does it every time the battery goes dead.

Year, brand, model would be helpful. You sure a speedometer cable is broke? If you have a newer car most of them have speed sensor(s). If a speed sensor is not working, it could be the problem with the shifting. Please rate my answer so I get points awarded.

Check the cables are not damaged if not lubricate them.

The speedometer is operated by a cable to the transmission. The gear selector is also a manual linkage. Neither are electronic. There may be something stuck underneath inferring with them directly.

THE SPEEDOMETER CABLE GOOD AND SPEEDOMETER NOT WORKING.2 POSSIBLE CAUSES WHILE ITS NOT WORKING SPEEDOMETER GAUGE BROKEN OR SPEEDOMETER DRIVE GEAR IN EXTENSION HOUSING BROKEN.

Its either your speedometer or your speedometer cable.
If it's these you will have to either have your speedometer gauge rebuilt or buy a whole new unit because they have to be re- calibrated. And if it's your speedometer cable I would also have a mechanic fix it. The cable is cheap but the gauges you can't fix on your own. So most places rebuild them and it's around $90-180.00 to rebuild them and they have to take the whole cluster gauges out all of them in the unit and they will usually replace burned out bulbs and fix the plastic gears in the gauges these are what usually fails before the speedometer cable.
Good Luck!

it may be the speedo cable some times the grease inside the cable housing dries up as fast as its turning friction builds melting the plastic a little and snap!! the cables broke.. either that or the little gear inside the tranny

Its your odemeter cable its run out of luburcation and its getting hung up. Reluburcate the cable