93 gsxr 750 was cutting in and out then stopped turns over but will not start put recon cdi on new coils checked the stand censor changed the ignition pick up coils no spark at leads still

SOURCE: no spark 110cc engine wont start

Check the fuses. Next, check for spark but with a new spark plug. How good is the battery? If needed, add water to the battery cells enough to cover the top of the cell plates.Try a jump start from your car battery. Is the kill switch on? Check the operation of the ignition switch with a volt ohmmeter. You should be getting power into and out of the ignition switch.

If the bike doesn't start and run properly check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. Broken or out of adjustment, it would kill the spark. Check for a broken wire at the switch or coupler. Get a service manual and check out the electrical section. Some bikes have a diode integrated into the turn signal relay. Try moving the kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it. If that doesn’t work, check out the relay.

Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing.

Please rate this answer. Thanks

SOURCE: 1996 zx11 getting sprk to one bank only

Hi and welcome to FixYa,

The voltage on the green wire must be pulsating when cranking/starting the bike, not steady. Confirm by similarly testing the voltage on the black wire on the left ignition coil. If the green still reads a constant voltage, then the CDI is faulty; to be more specific, most likely that the switching tansistor inside the CDI that drives the right ignition coil has shorted.

Good luck and thank you for asking FixYa.

SOURCE: 1983 yamaha xj 650 no spark already changed the

• Do you see spark? If not, check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. If broken or out of adjustment, it would kill the spark. Check for a broken wire at the side stand switch and coupler. Try moving the side stand kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it.
• Is the handlebar kill switch on? Is it shorted out?
• Are you getting power to the coils?
• Check the fuses. How good is the battery? Try a jump start from your car battery.
• Check the operation of the ignition switch and all kill switches with a volt ohmmeter. Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center or side casing. If still no spark, get CDI system and coils checked at the dealers shop.

SOURCE: ktm 450sxf 07 wont start

buy a yamaha

SOURCE: My 06 gsxr 750 will not start. New battery,

if the bike will not turn over you mean it doesnt crank? because if it doesnt crank over then its a starter issue and could be a simple as a blow fuse, but then why did the fuse blow? ( starter going bad)..... or it could be the starter solenoid itself, and this is where i believe you might find the fuse. response feedback appreciated.

Testimonial: "I appreciate the suggestions. This is exactly what I was looking for. Thanks. "