20 Most Recent
2007 Suzuki GSX-R 750 Questions & Answers
Gsxr in neutral turns off on stand
kickstand kill switch. disengage it by cutting the 2 wires then connect them together and tape up or solder and tape up then just remove the switch from the kickstand
My 2007 gsxr 750 f1 light came on and now the bike
The F1 light is really Fi, Fuel Injection. The fuel injection sensors have detected a problem in the system. Major problems will not let the bike start. You will need to get the bike to a dealer so they can hook up a code reader. The reader will pin point what the problem is. Once you know the source of the problem you can then decide if you can fix it or if it is time for the dealer to service the bike. Please rate my answer. Thanks!
Seeth91 model doesny turn over
even though the battery is charged it could still be bad and giving enough cranking AMPS. to engage the starter, try borrowing a good battery and trying it, if it woeks taht is your problem
2007 GSXR 750 was stuck
This will likely be one of two problems1....Your battery , even if it is showing 12 volts may be bad and not giving you the necessary cranking amps to fully engage the starter and turn the motor over2....Due to getting wet your wiring is corroded and needs to be cleaned, especially the ground, and then remounted tight.Try these and see if it helps
Ok heres my story. bike
you have to check all your wiring for broken, bare or loose wires. you may have to get your dad or someone else to help test them if you can't find a visual problem as sometimes they will stretch and break inside the plastic coating which will only be found doing a continuity check.
hope this helps
I have a Suzuki GSX-R
Odds are its your SET valve needing adjustment, have the codes pull on the bike. If it is the SET, you can
remove the SET system easily or you can have it adjusted.
If you get a code.
The codes are as follows:
C14 - THROTTLE POSITION SENSOR
C15 - ENGINE COOLANT TEMPERATURE SENSOR
C21 - INTAKE AIR TEMPERATURE SENSOR
C22 - ATMOSPHERIC PRESSURE SENSOR
C23 - TIP OVER SENSOR
C24 - IGNITION SIGNAL #1
C25 - IGNITION SIGNAL #2
C26 - IGNITION SIGNAL #3
C27 - IGNITION SIGNAL #4
C28 - SECONDARY THROTTLE VALVE ACTUATOR
C29 - SECONDARY THROTTLE POSITION SENSOR
C30 - SECONDARY THROTTLE CONTROL UNIT
C31 - GEAR POSITION SENSOR
C32 - INJECTOR SIGNAL #1
C33 - INJECTOR SIGNAL #2
C34 - INJECTOR SIGNAL #3
C35 - INJECTOR SIGNAL #4
C41 - FUEL PUMP CONTROL SYSTEM
C42 - IGNITION SWITCH SIGNAL
C46 - EXHAUST CONTROL VALVE ACTUATOR
C00 - NO FAULT
Bike starts but cuts off when put in gear for ome
Sounds like the kickstand safety switch is not making contact. There is a plunger type switch that the kickstand pushes when it is in the up position. The switch makes contact allowing the ignition system to operate. The switch is bypassed when the bike is in neutral, allowing you to start the engine. However, if the kickstand switch is not engaged when the bike is taken out of neutral, it acts the same as the kill switch on your handlebar. Some of these switches have adjustments and that may be all that is necessary. In a pinch, you can short the switch out (taking the two leads that go to it and twist them together) bypassing the safety circuit.
What make the tail lights and turn signals and
In most cases, if all those lights have stopped working at the same time, you have blown the "lights" fuse.
Replace the fuse, and check again. It should fix you right up replacing the fuse.
Not finding what you are looking for?