Cant get replacement center stand for hipster 125 would any other bike stand fit hope someone can help thankyou

SOURCE: Centre Stand 

hello i have a gsx 600f and this has two springs and a \´L\´ bracket but i also need a picture as of the spring arrangement you will also need if it\´s the same as mine prob\´s is two spacers and two bolts that have a hole in the end for spring clips you\´ll be best off going to a shop that supplies the bits, as i bought mine off ebay and it has cost me another £10 up to now for the extra parts if i get mine sorted I\´ll foward a picture to you send me your email address

SOURCE: center stand

1. Start with the bike on its side stand; 2. Grip left handlebar with left hand; 3. Grip frame member with right hand; 4. Place foot on center stand lever; 5. Pushing down on center stand, tilt bike till both legs of center stand touch ground; 6. Push down hard with foot and lift/pull on frame member.

SOURCE: battery removal

hi,

Remove the plastic panel on the left side of the bike just under the seat and you will see the battery. unscrew the metal bar that holds it in and simply slide the battery out.

SOURCE: my honda dylan ses 125 front wheel wont turn ?

brakes can freeze on use a fan heater hair dryer to bring the ambient temperature up and ease the pads back being careful not to bend the disc. You may have to pump the brakes and do this a few times to get them free, or you may need to take them off and overhaul them and get rid of corrosion, in which case get a cylinder repair kit and replace seals aswell. Brake fluid has a high water content but I have not heard of it freezing. What temperature has it dropped to?

SOURCE: exhaust pipe comes out white smoke when start bike on side stand

Continuous or just for the 5-10 seconds.
If continuous you may have oil seeping past your pistons oil rings or valve guides oil seals.
Check your spark plug see if they are fouled badly (covered heavily and oily) or just covered by oil and sooth lightly.
If 5-10 sec it is normal as the engine is heating up there are normally a little oil seeping past the seals.

Testimonial: "gives me more understandings on a bmw engine"