SOURCE: looking for motorcycle yamaha virago vx250 manual
Google " service manuals yamaha "
or go to www.repairmanuals.com
Please rate this solution. Thanks mjlj128!
SOURCE: won't idle steadily
Check the rubber boot that joins the carby to the engine to often have seen the hose clamps over tightened therefore creating a split in the rubber letting to much air in giving the rough idle eventually you wont be able to start it at all (have a good thorough look inside an outside of boot doesnt take much)
SOURCE: 1989 tw200 yamaha won't start
G'day egdbcs . Ok.now lets see.You say good spark,so i'm presuming you are doing the old sight test.Try bending the arm on a know good sparkplug about 5-6mm,earth the plug and kick'er in the guts(crank it over)Be very carefull , high voltage danger.If there's still a good spark it's safe to say that there will also be a good spark under pressure in the combustion chamber,speaking of which you should also do a compression test,anything over 100psi should be ok. as i'm not to sure of the extent of the re-build,hopefully the valves were lapped and checked for straight and true and valve seals replaced,if you notice oil on the tip of the spark plug you could have a leaking valve seal or oil seal .Try putting a small amount of fuel directly into the combustion chamber ,tighten up the spark plug ,install the plug cap and.......Yeah ..You guessed it ..."kicker in the guts".If all the abouve are correct and true it should fire up.If it runs for 5-10 seconds then stops you've got some sort of fuel starvation problem , could be dirt in the carb,blocked idle jet ,or air passage or even the needle could have come off it's clip,believe me with an old bike like yours anything could be worn and loose inside that carby.The only other thing to consider is the timing.There may be a good spark but is it happening at the right time inside the engine???. I'll leave it all in your capable hands EGDBCS.Hope this helps to solving your worries. Chow for now......Tilleydog..
SOURCE: 2007 yamaha virago won't start - replaced spark
it's not that your not gettin gas it's that the gas is not getting thru the carbs to the engine. your bike will probably start w/choke on and then die, your jets are clogged and happens to most bikes that are stored w/gas in the carbs.,,,clean them if you know how or take it to a trusted mech...good luck to you...Tim
SOURCE: 2001 Yamaha Banshee that won't stay running
If your jetting is too rich it will be extremely hard to kick start it and will most likely flood it from kicking.First thing i would do is pull the top of the carbs off (cable,slides and needles) and see which clip they're set at. If they are set stock which would be middle clip then lower the needle one clip. This will lean the mix out and should start up easier with no problems,The idle issue is most likely just off.If your fiance still has the TORS on it then on top of the carbs he will see 2 dime size and screws and wires as soon as he takes his seat off.While running he can turn each dime size screw in or out to adjust the idle. If it has a TORS elimator kit on it then he won't have all the junk on top of the carbs and it will be just a cable and round cap screwed directly on top of the carbs and the idle screws will be on the side of each carb (brass color screws with nuts to tighten) same thing...in or out to adjust the idle where needed.Hope this helps.
-Steve
539 views
Usually answered in minutes!
has this bike been in storage for a long period ?
×