Red warning light & EFI code will not go off

Sony Bravia TV kdl- red blinking led light error codes ...

? 10:28
https://www.youtube.com/watch?v=0KGysXbxnaU
Mar 28, 2015 - Uploaded by Tampatec
Sony Bravia LCD TV KDL models red blinking led light error codes & possible ... with perfect picture, no warning signs and it just shuts off. is it that quick? ... with the following problem: I connect the power grid lights Standby red light. ... the title before deleting, it is very fast after that flashes Standby 6 times.Missing: 46w3000 ‎30

1. 5 Amp (Tan) - Instrument panel lights and lights-on reminder
2. 20 Amp (Yellow) - Choke heater
3. 30 Amp - Circuit Breaker. Power windows and sunroof
4. 10 Amp (Red) - Electronic control module
5. 25 Amp (White) - Heater and air conditioning
6. 20 Amp (Yellow - Stop and hazard lights
7. 25 Amp (white) - Windshield wipers
8. 10 Amp (Red) - Radio and cruise control
9. 30 Amp - Circuit Breaker. - Power door locks, seats and rear window defogger
10. 20 Amp (Yellow) - Courtesy lights, key warning chime, power antenna, horns, cigar lighter and clock
11. 20 Amp (Yellow) - Turn signals and back-up lamps
12. 20 Amp (Yellow) - Parking, side marker, license plate and tail lamps
13. 10 Amp (Red) - Warning lamps and buzzers, trunk release, torque converter clutch and vehicle
speed sensor
14. Not Used

Hello, To erase the check engine light on a 1994 Camry, open the hood, and, in the engine compartment fuse box, remove the blue 15 amp EFI fuse for one minute. This will clear the codes. If you have a hard code; for example, a malfunctioning sensor, the light will come right back on.

Thanks

Please review this article: Where's The Fuse?




1. 5 Amp (Tan) - Instrument panel lights and lights-on reminder
2. 20 Amp (Yellow) - Choke heater
3. 30 Amp - Circuit Breaker. Power windows and sunroof
4. 10 Amp (Red) - Electronic control module
5. 25 Amp (White) - Heater and air conditioning
6. 20 Amp (Yellow - Stop and hazard lights
7. 25 Amp (white) - Windshield wipers
8. 10 Amp (Red) - Radio and cruise control
9. 30 Amp - Circuit Breaker. - Power door locks, seats and rear window defogger
10. 20 Amp (Yellow) - Courtesy lights, key warning chime, power antenna, horns, cigar lighter and clock
11. 20 Amp (Yellow) - Turn signals and back-up lamps
12. 20 Amp (Yellow) - Parking, side marker, license plate and tail lamps
13. 10 Amp (Red) - Warning lamps and buzzers, trunk release, torque converter clutch and vehicle
speed sensor
14. Not Used

Hi there,

The 16pin Diagnostic plug is situated inside the vehicle, usually under the dash, above the knee of the driver (on either side of vehicle).

This is what it looks like:


If you do not have the appropriate scanner, you can retrieve the computer diagnostics by the following process:

1) turn key 'off'
2) connect pins 1 & 4 of the connector (using a suitable jumper wire)
3) turn key to 'on' (do not run engine)
4) any fault codes present, will flash the appropriate warning light on the instrument cluster. E.g. if you have an ABS fault, the ABS warning light will flash. If you have an EFI issue, the Engine Light will flash etc.


Cheers,

Dont have the manual in front of me...recollect that there's two types of warnings. The pulsating warning is oil (starts with 30 minutes of oil left) or the fuel filter (or sperator, something like that) may have water in it. Running outboard with cover off, is a little black box that would have a red light lit if that's the case. If oil full & no red light, may be oil injection system...would also check to make sure lines aren't pinched, etc. Mine has been specific to oil the two times its gone off.

The full non-pulsating is engine overheat. Not sure beyond that.

Not much, but hopefully gets you going.

You need to call the dealer and ask them but most of the time warranty repairs are free. When you call, ask to speak with the service department. Explain you have a 2009 and you think it is under warranty. Then describe the problem and ask how much they will charge to to LOOK at it. Then ask if it is covered under warranty and if not what the estimated charges will be. Often they don't know exact amounts until they look at the bike and figure out what is wrong with it, but looking at it should be free under warranty.

If you are not happy with their response you can find another dealer.

The warning light and EFI will disappear once you fit power valve :)

I've got 2008 Aprilia RS125 and CDI I derestricted first.. I had warning light on until I fitted power valve.. No warning light now.