Light with red triangle on it
SOURCE: ABS light flashs - push switch and it stays on completley
it is caused by low battery voltage run bike for about a mile then stop turn of turn back on wait till abs lights go out then start
SOURCE: red light star on dash came on what is it
The red light indicates an ABS fault. You can try to reset it.
Also, i have seen these lights be triggered by low battery voltage, dirty sensors, low fluid level.
Hope this helps...ride safe...ride smart.
SOURCE: My 2002 K1200RS cruise control has stopped
check the brake pedal switch, mine was to close to coming on all the time and would flash the light on bumps not allowing the cruise to engage untill I bent the little tab to hit the microswitch sooner and stay touching it.
SOURCE: Red warning triangle with straight line in
ok buddy, how long do you wont to live for???????
this flashing warning light is your ABS light!!!! like your brakes dont work right!!! look at the brake hydraulic fluid level, is it full up???? you could turn off your ABS by pushing down on No 3 switch along from the left on the lower switch pannel, but its your neck, also try starting the motor them put on both brakes (front and back) hold them on for a fuw seconds before you pull awaythis could reset the ABS, but get it sorted fast
SOURCE: I just received my bike
next time you start her up put on the frount and back brake together,,,this should put out the red light,,,,if it dont you have an ABS censor fault clean the censors and the ABS gearwheels on the wheels and reset the ABS
373 views
Usually answered in minutes!
×