20 Most Recent 2002 Honda STX 1300 Pan European - Page 9 Questions & Answers

https://www.youtube.com/watch?v=Xrn58yenvBsIf you have clutch master cylinder and slave cylinder might need bleed air out.https://www.youtube.com/watch?v=wCj8QiIo4ssRemember when bleeding brakes keep the master cylinder full of oil or you will suck air back in line. Should have 2 hole in bottom of master cylinder. Make sure holes are not plugged. One the fluid goes out the other the fluid comes back in.https://www.youtube.com/watch?v=YP195yHIsIkhttps://www.motorcycleforum.com/threads/hydraulic-clutch-problems-88-honda-shadow.92072/https://www.youtube.com/watch?v=n2eMTnMhFew

here is the place for you https://www.carlsalter.com/honda-service-manuals.asp

It may due to the loose screw, go to the mechanic.

https://www.manualslib.com/manual/811004/Honda-Jazz.html?page=378#manual

theres a few workshop manuals that may help here https://www.carlsalter.com/honda-service-manuals.asp

https://www.hondashadow.net/threads/torque-specs.122143/ Read this post for the torque specs on the bolts.

Hi, spark gap 0.7 all the beat.

i think it has some engine fault or engine oil level maybe low. you should check it properly and try to start it again.

https://www.vtxcafe.com/threads/starts-then-dies-then-will-not-start-again.72942/ https://www.vtxcafe.com/threads/bike-starts-then-dies.59937/ https://www.vtxcafe.com/threads/stalling-and-black-spark-plugs.51516/ https://www.vtxoa.com/threads/engine-stall-and-die-finally-fixed.328597/ https://www.youtube.com/watch?v=Tx9fb1Ytz8k https://www.youtube.com/watch?v=CymFLDrKNoQ

Cycle salvage shops in ur state etc hav parts. Archway in stlouis is huge. U cud try takn that switch apart to solve or just hotwiring when u start it. Buy a clymer or haynes manual for totalbike rebuild

Has this vehicle been regulary serviced ? these syptoms could be a numbers of things, i would have the ignition system checked, and the fuel and air delivery as a starting point

http://blog.hondalawnparts.com/how-to-change-a-honda-ht3813-pto-clutch/

Snug, not loose. Between 6 to 9 ft lbs. torque on the bolts. Higher torque will strip aluminum threads.

Online..utube..pinterest

I had to take mine to a man in Berwick and he did it for me really cheap. He has his own place. If I find his name I will send it to you. He charges less than half of everyone else.

Question: Where to find cam shaft sensor on Santa Fe 2001 2.7 GLS Answer:

please look at list on this link. your choice... https://www.manualslib.com/manual/677490/Honda-Cbr600f4i.html -----------

Does it crank, that is first , starting is 2nd. if it cranks, but will not start. that means you lost spark , check for spark if spark is good, check fueling

more than likely its in the gas tank

Battery shud read 12.6 v always for a coil ign. It cud b old or not chargn frim alternator or the chargn wire is worn. Coil itself probly agin..old bike. Salvageyards hav parts