20 Most Recent
2004 Honda STX 1300 Pan European Questions & Answers
Access battery
Do you want to connect you electric vest directly to your battery or you want to create a plug point so you can plug and unplug the electric vest? Normally your battery should be accessed from a cover panel on RH. Good or excellent?
Lights
its the normal because one for low beam and the other for high beam
Battery removal
Unlock the left hand seat lock, lift up the lock, inside is a small lever, depress this and seat will come off. To access the battery after seat removal there are three (3) pan head bolts holding on the side panel remove these carefully and this will allow full acces to the battery.
Can you advice me the proper way of removing the
You have your listing under a 2004 Honda. You gotta thumb drive on that thing or what? I'm mean cool if you do but if your taking thumb drive for a computer then here's what to do.
If you are using Vista:
Close out any programs you are running off the thumb drive and/or stop or wait till it's finished any importing or exporting from it as well.
In windows explorer right click the thumb drive and select "Safely Remove". It will tell you when it's good to go or if you need to wait.
XP:
There should be an icon in the task bar (lower right hand screen), When the cursor is over it it will say "Safely Remove Hardware". Right click that and then left click the drive you want to remove. Again it will let you know.
To be honest I have pulled mine out without those steps and it never complained other then running disk scan after I put it back in.
Hope this helps and good luck.
STX Honda 1300 cc motorcycle brakes effectiveness
souns possible that the pads have become glazed a very light abrasive to the pad face should help wearing pads in on bikes is never the same and it depends on the type of pad you use the higher friction copper based are the better and worth looking into as they last longer and protect the disk also hope this helps you
Aid the front suspension
if your bike likes to wander at high speed these fork braces can help.
how ever do some research on the manufacturer of the brace to make sure it is of good quality
hope this helps
Cruiser control
It is not necessary but a bit uncomfortable and your hand can cramp you have to keep your hand on the throttle grip
manual cruise controls are easy to install
check this group out for controls
accessories International
13343 SW 131 ST
Miami FL 33186
Toll Free: 888-725-3679 (M-F 9AM-7PM EST)
Fax: 786-242-4151 Int: 786-242-5400
Cleaning
A bucket for soapy water
Soap or liquid detergent; automotive cleaners will work
Gloves (to keep your hands clean)
Bug and tar remover
Degreaser and/or engine cleaner
A toothbrush
WD40
A brush for wheel cleaning
Wheel cleaner
At least two microfiber or 100% cotton sponges
A variety of soft cotton towels and more abrasive rags
A chamois cloth for drying
Engine vibration and chatter when
That could be caused by clogged up spark plugs or oil in the combustion chamber in turn causing pre-ignition.
Check the compression and maybe the condition of the ignition system/timing.
Some times the thermostat
I should replace the thermostat and check for air locks before you cook your engine.
The UK Police used a few ST1100 bikes but they were too slow and use R1100 BMW mostly now.
Honda PC50 moped VIN decoder
To read the serial number on a Honda PC50 moped, follow these steps:
Locate the VIN (Vehicle Identification Number): The VIN is a unique code that provides information about your moped. On a Honda PC50, you can find the VIN in the following places:
Under the Air Filter Cover: Look on the left-hand side, just above the engine. The VIN should be stamped there. It typically looks like this: PC50 - 1234567.
Frame Number: The frame number is another term for the VIN. It's usually located near the air filter body.
Decode the VIN: The VIN contains important details about your moped, including the year of manufacture. Here's how to interpret it:
The 9th digit of the VIN is a check digit.
The 10th digit represents the year code. For example:
A = 1980
B = 1981
C = 1982
D = 1983
E = 1984
F = 1985
G = 1986
H = 1987
J = 1988
K = 1989
L = 1990
M = 1991
N = 1992
P = 1993
R = 1994
S = 1995
T = 1996
V = 1997
W = 1998
X = 1999
1 = 2000
2 = 2001
3 = 2002
Note that if your scooter was manufactured between February 1986 and February 1987, it's likely to be a '87 model;
Additional Resources:
If you have the full VIN, you can use the NHTSA VIN decoder to get detailed information about your moped.
Alternatively, you can call Honda with your VIN, and they will provide you with the necessary information.
4/23/2024 11:45:02 PM •
Honda...
•
Answered
Yesterday
Honda 500 TRX fa6 has PS on the dash….what does it mean ?
The Power Steering has failed. There has been a factory recall for a suddenly failing electrical steering shaft, that could cause the rider to loose control. This does not have to be your problem but anyhow either the electronics or the pump failed. Error codes or messages usually have to be erased by a simple reset procedure or disconnecting a plug, after repairs are done.
3/31/2024 4:25:47 AM •
Honda...
•
Answered
on Mar 31, 2024
Not finding what you are looking for?