20 Most Recent 2011 Hero Honda Super Splendor 125 Questions & Answers

It's because you have a bad ground, the filament is providing a partial ground, same with the horn. Make sure all your grounds are good... most likely answer without seeing it.

Its under warranty, take it back.

take the dirt out of the tank . run it till its about empty, or will barely run. Cut the gas off to the engine and run it dry. Take the tank off and turn it upside down and drain it. Put just a tint bit of fuel in the tank, cap itt off, shake it, and drain it again until the fuel comes out clean without dirt. Look inside the tank with a flash light (not matches, lol) and see if it is rusted. if it is rusted you will have to fill it with penetrating oil and shake it every few hours for a few days to eat up the rust, then rinse it with fuel, and try it on the scooty again

Who's TNT?.. it's a fireworks stand where I live..??

remove carb, drain fuel leave for a few hours, and heat the screw, use pliers to gently remove.

May need a higher rated fuse or put through a relay. Otherwise no problem at all.

Over time the head blots stretch and have to be retorqued.

Can't run tubeless tyres with spoked wheels.