2006 Ford Five Hundred Logo

Related Topics:

Posted on Feb 21, 2018

Alarm 2006 ford five hundred...locked the doors and alarm came on. Now getting in the car we turned the alarm off like normal but a light is still flashing inside that its locked and we cant turn the key at all. Please help the lights inside the car won't even turn off after locking the car.

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Mar 16, 2009

SOURCE: 2006 Ford Five Hundred -- Where's the fuel filter?

right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.

Ad

Anonymous

  • 2 Answers
  • Posted on May 19, 2009

SOURCE: 2006 aveo alarm system

this happened to me and it drove me crazy for a few days. check that the hood is closed tightly. its held shut for the most part by a peice of metal with a screw on one side, a spring around it, and a nub looking shape that fits into the locking device above the bumper. When i finally checked my hood, the entire bit of metal had come unscrewed and was stuck in the locking device, leaving my hood held shut only by the safety clamp. remove it from the locking part and screw it back into the hood, closing it a few times to find the right distance to screw it in. lock your car and hear that chirp, that should fix it

if thats not the case then check that all of the doors are closed nice and tight... if the doors lock but the audible alarm is not armed then that is most likely the case

Anonymous

  • 1305 Answers
  • Posted on Jun 16, 2009

SOURCE: 2006 Ford Five Hundred traction control light on all the time.

This is a computerized traction control system that monitors the wheel spin and makes split second adjustments... if the light is on, Ford recommends servicing the system. I'd check with a local non-dealer mechanic that may be able to help you out cheaper than a dealer first.

roniecon

Ronny Bennett Sr.

  • 6988 Answers
  • Posted on Aug 26, 2009

SOURCE: = 07 ford five hundred ac problems

First off,is the ac compressor turning?If so are the large line,near where you put freon in,cold?If the low side lines(large lines)are cold and sweating,and the evaporator box is dripping water on the ground,then the ac is most likely fine.There is a temp door in the ac blower box,that moves for hot,or cold when you select these comfort levels.This door is most likely controlled by a actuator motor.This motor is most likely bad.If it is control by vacuum,look for a broken vacuum hose,or one that has come loose under hood.

Rob Dinkel

  • 19 Answers
  • Posted on Jan 04, 2010

SOURCE: ford five hundred has flashing light on dash for

sounds like chip key is not communicating with host computer. Part of anti-theft. probably a good idea to see dealer.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do i to fix a ford five hundred car stuck in park?

If it is locked in park, it could be the brake switch or the shift lock solenoid. You may be able to shift out of park before you turn the key switch to the on position.
0helpful
1answer

How to reprogram a key fob for a 2006 ford 500

You are in luck! You can program a 2006 Ford Five Hundred key fob yourself and don't need to go to a dealer or professional. The steps are pretty easy, it's the timing of the steps that you have to pay attention to. You most likely will not get the programming correct on the first try, keep at it, you will get it.

Here are the key fob programming instructions for a 2006 Ford Five Hundred:
*** THERE ARE 2 POSSIBLE PROGRAMMING PROCEDURES. ***Procedure #1Note: Obtain all remote transmitters for this vehicle.
Note: Do not depress the brake pedal during procedure.
  1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
  2. Within 20 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 4.
  3. Within 20 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 3. For all other remotes.
  4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

    Procedure #2Note: Obtain all remote transmitters for this vehicle.1Fasten seat belts and close all doors.
  5. Turn ignition from OFF to RUN 4 times within 6 seconds, with the 4th time ending in RUN. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
  6. Turn ignition to OFF. Acoustic signal will sound and system warning lamp will illuminate to confirm programming mode.
  7. Within 10 seconds, press and hold any button on the first keyless remote. Wait for acoustic sound and warning lamp to flash (confirming programming) then release button on remote. Wait 2 seconds but within 10 seconds repeat step 4. For all other remotes. If you only have one remote then continue to step 5.
  8. Turn ignition to Crank or wait 10 seconds to end programming mode.
Make sure you have a spare key fob too. You can save a bunch of money ordering a spare key fob online at:
https://www.keylessentryremotefob.com/Ford-Five-Hundred-Remotes-and-Keys-s/5167.htm
0helpful
2answers

My ford five hundred won't turn over the lights are on but when i turn the key to start nothing happens this is after it sat for 8 months and the battery went dead. I charged the battery completely and the...

the battery is probably badly sulphated and has cell problems
use a load tester to check the battery
after that use a scan tool to reset the ECM program as the CPU is corrupted
0helpful
1answer

The key wont turn to start the car....red light flashes with a lock icon

does the key have a clip in it ,and do you have the keyless entry . you may need a new key from the dealship
0helpful
1answer

Ford Five Hundred head lights and dash lights are flashing.

I would check battery voltage with a meter when the lights are flashing to check alternator output. Might be a ground problem.
0helpful
1answer

Reset anti theft system for 2006 ford five hundred

Ford PATS doesn't have a reset like GM. First try a different key and disconnect all electronic devices in the car like phone charger, GPS, dash cam, etc. If that doesn't work, you'll have to get the trouble codes read
0helpful
1answer

I need to reset the ani theft system in my ford five hundred 2005, what can i do??

Sometimes jus using your keypad unlock and lock your doors with it if that don't work try your manual perhaps a code could be entered into your radio to disable the theft system!!
0helpful
1answer

MY ANTI-THEFT INDICATOR IS ON. NOW I CAN'T START MY CAR.

What do you mean by "ON"? A light flashing? A warning Lighton?

Normally, just locking and unlocking the doors will reset teh alram.

Need more info
3helpful
1answer

Ford five hundred has flashing light on dash for engine lock out. key will not turn over to start engine. book says to see dealership

sounds like chip key is not communicating with host computer. Part of anti-theft. probably a good idea to see dealer.
Not finding what you are looking for?

173 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...