Cars & Trucks Logo
Posted on May 30, 2011
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Car sat in parking lot for 3 days, with a lot of rain. Upon start up Check Engine & VSC began to flash. Car ran normally for 2 miles. Pulled over shut down car, waited 10 seconds re-started engine with same indications. Drove 25 miles at highway speeds, transmission operated normally, electronic throttle operated normal and responsive. Any ideas before I take it to the dealership and have it checked for fault codes?

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Brigadier General:

An expert that has over 10,000 points.

  • Master 4,669 Answers
  • Posted on May 30, 2011
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Brigadier General:

An expert that has over 10,000 points.

Joined: Feb 27, 2009
Answers
4669
Questions
0
Helped
1847686
Points
16674

It likely had water on the ignition system. The check engine light will flash for misfire. The VSC light is on just because the check engine light is on. You likely have it dried out now and its fine. You just need to clear the codes. Autozone will do this for free.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Truck will start but engine dies and service engine soon light comes on/truck was idleing fine for 10 minutes then began to hesitate then shut off when first happened

When the engine dies the Check eng light is supposed to come on. You need to do a fault code test on the OBD2 engine control module.
0helpful
2answers

96 Benz ran out of gas other day, got it filled up & drove home (20 miles). Next day drove about 40 miles, left car running in park for about 15 min, when I left car was stalling like it was running o

You never leave a car running, as it will
overheat the Exhaust Converter
When you run out of fuel, you sometimes
ruin the Fuel Pump
It depends on gas to lubricate it,as strange as it sounds
Check fuel pressure & volume at the motor with a gauge
0helpful
1answer
0helpful
1answer

Check engine light on

I hope you havn't power cleaned the engine at any stage,,,,,, Check for moisture or even water in the spark plug wells . The HT leads should be tight ,clean , dry and not overlapping ie a HT lead seperator should be able to keep leads from touching and a possible mis fire.
0helpful
1answer

Check Engine Light Flashing Briefly and Throttle revving

go to a shop and see if there is a code stored in memory. anything else would just be a blind guess. If you are near an Autozone that do a scan for free
20helpful
3answers

My 2007 Toyota Tundra 4.7l shows VSC OFF lights

check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me
0helpful
1answer

96 Jeep Cherokee stall then hard/no start

change fule filter if nothing changes do fule pressure test
Not finding what you are looking for?

656 views

Ask a Question

Usually answered in minutes!

Top Lexus Experts

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...