At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: Hi, can i program a new remote on my 05 RA rodeo...
If you have a working remote most locksmiths now supply and reprograme new remotes. Look them up in the phone book. If you have dont have a working remote you will have to go through holden.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
forum.australia4wd.com > ... > Rodeo,Colorado and DMAX Technical
Nov 5, 2011 - 7 posts - 4 authors
posted in Rodeo,Colorado and DMAX Technical: My reversing lights ... switch as per workshop manual..could someone throw me a bone here...thanks. ... Started By rodeo5 , Nov 05 2011 04:35 PM ... My 4WD:RA 07 Rodeo; State:NSW ... would say the reverse switch would be on the gear box some where ...
stage 1 = 29Nm(21 lb ft/3.0 kg-m)
final = 64Nm(47 lb ft/6.5kg-m)
do not reuse head bolts or apply any lubricant to the bolts. Do up bolts in following order for each head.
6 1 3 7
front
5 2 4 8
if its early 05 round heart shaped remote it needs programming into system at dealer with Tech2
later 05 to 07 had square (rectangle) shaped remote 1.2 ID Code Additional Registration Note: This procedure will add additional remotes to the Keyless Entry Control Units memory. A total of 4 remote transmitters may be programmed into the Keyless Entry Control Units memory. When a total of registered and newly registered remotes exceed 4, the oldest one shall be erased. Step Action 1Note: Make sure that all the doors are closed and unlocked. Insert the ignition key into the ignition switch. Open the driver's side door. 2 Turn the Ignition key to the “ON” position and then to the “LOCK” position three times (The key should remain in the “LOCK” position) Note: This step must be carried out within five seconds. 3 “CLOSE” and “OPEN” the driver’s doors once (Leaving the driver’s door in the “OPEN” position) Note: This step must be carried out within five seconds after step 2 is completed. 4 Wait for 8 seconds (This wait time is critical) 5 Turn the Ignition key “ON” and then to the “LOCK” position once and turn key to the “ON” position (The key should remain in the “ON” position) OR on/lock once Note: This step must be carried out eight seconds after step 3 is completed. 6 “CLOSE” the driver’s door The HAZARD lights should flash 3 times (This acknowledges the Keyless Entry Control Unit has entered programming mode) 7 Operate the lock or unlock button of the transmitters to be programmed; a flash of the HAZARD lights indicates the remote has been successfully programmed into the control unit 8 The HAZARD lights will flash approx 4 seconds after pressing the remote button to indicate the Keyless Entry Control Unit has exited programming mode.
×