Slave cylinder is leaking fluid - 1992 Honda Accord

Replace the clutch. throw out bearing, and pressure plate.

no fluid in the clutch reservoir due to a failed clutch slave cylinder
time to replace both the clutch slave and master cylinder

If its leaking fluid then it needs replacing. If you cannot see fluid dripping from it gently remove the rubber boot on the slave cylinder side as sometimes the rubber will hold the leaking fluid. If their is no fluid leaking then the slave cylinder is ok.

Hello buiskit: My name is Roger and I will help you. If the fluid runs down the firewall or leaks down on the floor board or on your foot. The problem should be the clutch master cylinder. However should the fluid leak at the bell housing area.Then the problem is the slave cylinder. To replace the slave cylinder you will need to pull the transmission in order to replace the slave cylinder. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger

Check the fluid for the clutch. It has a small master cylinder next to the brake master cylinder. It should use brake fluid. If it is low, top it off. If it goes low again, you'll need to investigate where it's leaking from. You could have a leaking master or slave cylinder.

Yes, hydraulic--check again--fender side of brake master. Slave is usual cause of leak that eventually causes master reservoir to go dry and start drawing air. Check slave for leak. If leaking, replace slave and bleed system. Make sure to bench-bleed slave before installation by opening bleeder and pouring fluid into line port.

1. Raise and support the front end on jackstands.
2. Back off the flare nut on the fluid pipe to free the slave cylinder hose.
3. Pull off the hose-to-bracket retaining clip and pull the hose from the bracket. Cap the pipe to prevent fluid loss.
4. Unbolt and remove the slave cylinder.
5. Installation is the reverse of removal. Tighten the bolt to 12-17 ft. lbs. (16-23 Nm).

The clutch is not adjustable,it is a fluid clutch.It has to be a leak,or the slave cylinder,and,or, the master cylinder are bad,It does not have to be leaking to be bad,but it is one of the two.Rate please,thank you.

more than likely the slave cylnder in the tranny or on the side of the tranny have you been seeing fluid on the ground.

Slave cylinder should be on the left side of the bellhousing (follow the line from the clutch master if necessary) If you don't see fluid but you have lost some, also check where the rod from the pedal goes through the firewall to the master...they often leak there and will not drip on the ground.

Its sounds like a bad clutch cylinder or bad slave cylinder or fluid leaking. First check brake fluid level in clutch master , and check for a leak in clutch system. If there are NO leaks, then you either have a bad clutch cylinder or a slave cylinder. Bleed clutch at bleeder screw on slave cylinder and make sure there is pressure from master cylinder. If there is pressure then slave cylinder may be bad replace slave and bleed and that should take care of you problem. If master is bad then replace bleed system ad you should be good. Contact if you need more help. Thanks for using FIX YA.