There is a TSB for this condition that has a new nozzle kit. Here are the instructions to replace the nozzle
Trim Removal/Installation - Tailgate Area
Special Tools Required
* KTC trim tool set SOJATP2014
* Available through the American Honda Tool and Equipment Program.
NOTE:
* Put on gloves to protect your hands.
* Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
* Take care not to bend or scratch the trim and panels.
1. Remove the tailgate upper trim panel (A).
2. Disengage the hook (B) and tabs (C) from the left tailgate side trim (D) and right tailgate side trim (E).
3. Pull the tailgate upper trim panel by hand to detach the clips (F, G, H), then remove it.
08-034
June 13, 2008
*Applies To (see VEHICLES AFFECTED*:
2007-08 CR-V: Rear Window Washer Nozzle Is Missing or Broken (Supersedes 08-034, dated May 16, 2008, to update the information marked by the black bars and asterisks)
SYMPTOM
The rear window washer nozzle is missing or broken, and washer fluid leaks into the vehicle's interior.
PROBABLE CAUSE
The rear washer nozzle was damaged by an ice scraper.
VEHICLES AFFECTED
CORRECTIVE ACTION
Install the updated rear washer nozzle kit.
PARTS INFORMATION
Rear Washer Nozzle Kit
WARRANTY CLAIM INFORMATION
In warranty: The normal warranty applies.
Operation Number: 7421A7 Flat Rate Time: 0.2 hour *Failed Part: VIN begins with JHL: P/N 76850-SWA-003 H/C 8518573 VIN begins with 5J6 or 30Z: P/N 76850-SXS-A01 H/C 8473266* Defect Code: 01801 Symptom Code: 05909 Template ID: 08-034A (Japan-built) 08-034B (Ohio- and Mexico-built) Skill Level: Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1. Remove the tailgate upper trim panel:
^ Refer to page 20-78 of the 2007-2008 OH-V Service Manual, or
^ Online, enter keywords TRIM REM TAIL, and select Interior Trim Removal/Installation-Tailgate-Area from the list.
2. Pull the washer hose off the the rear nozzle, and remove the nozzle and the nut.
3. Install the new nozzle with a new nut onto the glass.
4. Reattach the washer hose to the nozzle.
5. Disconnect the washer hose between the body and the tailgate, then remove the hose joint.
6. Install a new check valve joint with the arrow or the taper pointing towards the nozzle.
7. Reinstall all removed parts.
8. Test the rear washer for proper operation. If the spray area is not within the standard position, adjust the nozzle
Cost Washer Nozzle 76810-S10-A01
Hope this helps.
1,183 views
Usually answered in minutes!
×