SOURCE: HOW DO I REPLACE MY TURN SIGNAL LIGHTS ON 2003 HYUNDAI TIBURON
I just found out today that it is a problem for alot of 2003 tiburons that the flasher relay for the turn signals will go out causing the turn signal lights to stay on even with the car off. The relays are internal and located on the circuit board of the BCM. In order to fix you will have to remove and disassemble the bcm circuit board from it's housing and resolder a new flasher relay. Haven't figured out where to get that flasher relay though.
SOURCE: S430 turn signal relay location?
It is the combination switch on the end of the turn signal stalk see diagram for E-Class same switch
it is S4 in diagram
SOURCE: 1989 Lincoln Town Car Turn Signal Relay location
Thats strange they should be on the fuse panel ! Are you sure !!!!
SOURCE: Where is the Turn Signal relay located on a '00 Intrigue?
It's up under the left side of the dash, attached to the same bracket as the body control module. But sometimes the problem is in the hazard switch - try pressing it when the signals don't work and that often brings them back to life. Also, check the ground wire to the left of the base of the steering column.
Turn on the Durango and check each of the four turn signals
to make sure that the bulbs are not burned out. If you find one that has gone
out, replace the bulb and retest the turn signals. When a bulb goes bad on this
circuit, the resulting operation can mimic a bad flasher or one that is
failing.
Locate the combination turn signal flasher and relay. It is
on the left end of the driver's dash. Open the access door and view the
collection of relays and fuses. At the left side of the mounting block is a
larger flasher and relay. This is the combination turn signal flasher and
relay.
Test
the relay by placing you finger on the relay housing and activating the turn
signal. If you have found the right one, you should feel a clicking as the turn
signal blinks. Remove the relay, replace with the new relay and close the
access door
.
Start the Durango and activate the turn signals to check that they each work. The light should turn on and should blink. Also, check the hazard lights to make sure they work.
417 views
Usually answered in minutes!
×