Locate crank shaft sensor on 1998 jeep grand cherokee

The Crankshaft Position Sensor (CKP) is located at the rear of the block behind the bell housing. The Camshaft Position Sensor (CMP) is located inside the distributor. ....Reach behind the engine on the driver's side and down to the bell housing for the trany its on top of that.

Jeep Crank Sensor Replacement, P Codes P0351, P1391 ...

? 6:24
www.youtube.com/watch?v=7D0vUEDSwXo
May 12, 2013 - Uploaded by Robert DIY Replaced the crank sensor on this 2003 Jeep Grand Cherokee.... to replace my crankshaft position sensor on my 1998 grand cherokee laredo.

Jeep Crankshaft Position Sensor Replacement (CKP, CKPS ...

? 4:07
www.youtube.com/watch?v=1Ho5iAKQV00

Oct 27, 2013 - Uploaded by WeekendHandymen
hi , do you think if I replace crank sensor will solve the problem ,my jeep .... Where's the crankshaft located in 99 jeep grand Cherokee laredo .

you need to check all sensor connections as the crank shaft sensor also will mess up your idle....try slightly unscrewing the tps and push it up or down slightly to see if this fixes the problem.

still bad. still guessing?

no easy way best way to remove the front drive shaft and do it from under the jeep

CRANKSHAFT POSITION SENSOR LOCATION FOR 4.0L ENGINE IS ON TRANSMISSION BELLHOUSING AT THE LEFT REAR OF THE ENGINE. FOR 5.2L ENGINE CRANKSHAFT SENSOR LOCATED ENGINE BLOCK BEHIND THE RIGHT CYLINDER HEAD.

there are two sensor in the jeep grand cherokee one is located under car on top of i think it's the cam shaft. the other one is located under distubutor cap that is where they are located on my 95 jeep cherokee. hope this help i had to change both. you should just have to plug both in and put back where orig. parts was connected.

at the rear of the engine by the tranny. see pic below.

97 cherokee crank sensor replaced, still shuts off, code 351

Crank shaft sensor is a good place to start.