You have to remove the bumper first...
Tools Required:
- socket wrench/socket kit
- 8mm socket
- 10mm socket
- flathead screwdriver
- flathead stubby
- torx driver set
Optional Tools:
- car jack
- monkey (to hold your work lights)
Instructions:
- jack up car (optional)
- At least jack up one side of the
car
1) Remove 4 screws on top of bumper ( under hood, above kidney grills)
2) Remove 2 screws in each wheel-well, and clip bumper trim away from
wheel-well trim
3)Push wheel-well trim away so you can unfasten 2 screws inside that hold
top part of bumper to the car on each side
4) Release about 7 Screws on bottom of bumper from underneath
5) Remove bumper by uncliping each side and then pulling bumper forward
Foglights will stay in place. simply disconnect the cable.
After you remove the bumper and unplug the Foglights
1) To remove the lights you also need to remove the bracket that hold
the lights
2) Remove the blots on the bracket and top of headlight.
Installation is in the reverse of removal...
SOURCE: need to replace bulb, need
You did not mention which bulb you need.
For BMW part numbers, go to RealOEM.com
2,055 views
Usually answered in minutes!
×