Rear wiper My rear wipers work but it doesn't squirt washer fluid.

could be a clog in the line, or blockage at the spray tip, if its on a seperate switch from the front washers check to see if the pump is engaging while the button is pressed, if all washers are activated on same button it is probly the line or nossle tip.

Do you have power and ground at the wiper motor ?

Yes it does and the washer fluid reservoir under the hood is for both the front and rear. The following is a diagram of the washer pump and hoses so you can check for operation or leaks.

http://www.nissanmurano.org/forums/attachments/problems/15059d1233342517-rear-washer-fluid-not-squirting-washer-motor.jpg

if it is cold, then your washer fluid has frozen in the lines. it will work again when it gets above 32 degrees. if you buy the 1.29 a gallon brown winter stuff instead of the .89 a gallon blue summer stuff you will have better luck next cold snap

go to a service station with an air compressor and with the air turned down to about 20 lbs blow into the washer top small hole to force fluid thru the hoses,not a lot of pressure so you blow hoses off or rupture something

I have the same problem with my 2000 chevy blazer as skornec had posted. I kinda already figured the hose or spray nozzle was plugged. But the problem with checking those items is that I don't know where the hose is located to the back wiper. And the only thing that could be I see that could be the spray nozzle doesn't even have holes that washer fluid could spray from. So basically I just would LOVE if someone could please inform this lame brain of where to find the spray nozzle on the rear window and where in the interior of my blazer does the washer hose run.

your rear wiper motor might be faulty,in the front i would check your fluid level-if it is full and you hear the pump running-check your washer lines to see if they are pinched-usually around where the hood closes

it's likely the tiny motor/pump located at the bottom of the tank that has failed. to confirm this have some turn on the washer fluid switch and test for voltage at the pump. there are several aftermarket pumps you can use as a replacement.

I had the same problem. I thought it was an issue with a blown fuse, but also noticed that the rear wiper was very stiff.
I solved it by opening the rear window (so the wiper is not clicked into the motor) then squirt some WD40 into the wiper mechanism (I put the oil in from the outside). Gently move the wiper from side to side until it starts to free up - after a couple of movements the wiper should be moving freely again. No issues since.

At the same time, check that the washer jet is correctly angled. Mine was squirting directly into the wiper which may have caused it to rust up a bit.

the washer fluid is on the back,sometimes you need to takeoff the cover