I need to drain the coolant so i can flush my raditor where is the drain located

Usually located on the passenger bottom of the radiator facing the engine. You should feel like a butterfly nut made of plastic. Its not going to be on the metal parts where the air flows through but on the side tanks

put fuel injection cleaner in gas tank, put flush in your coolant system drain completely then refill with manufacture recommended coolant.

drain raditor fluid then take off upper and lower hoses and put your house water hose in lower raditor hose and turn on water and let run for about 5 mins. to flush out raditor.
then run in top hose to flush back then lower hose again. that should clean it out.

If you want to flush the raditor remove the big hoses, don't worry with the drain plug as you can't flush it good enough with the drain open anyway. If your just changing the fluild you can drain it and fill it but thats not flushing it. remove the therostate too and flush the engine and remove the heater hoses and flush them too. As you may not know what kind of antifreeze is in the motor now you need to get all of it out as some kinds of antifreeze don't mix and make a clogging slime instaed of good coolant. Do it right or take it to a shop that will.

There is a drain plug on the engine compartment side of the radiator at the bottom of the plastic tank. The best way to flush your cooling system is to get a Prestone Raditor Flushing Kit. You can use a garden hose to flush the system out.

Ok looking at all different Manufactors, and i have'nt seen one with a radiator drain plug..So if you are tring to flush your raditor, just take off the bottom radiator hose, and run a hose in the radiator, and flush it out the best way you can...Then top it off with a Gallon of coolant, and you should be fine...Goodluck...

Yes it usually screws in. Depending on it's location you may have to drain the radiator and save your coolant to re-use. Most of the time it's high on the engine so you don't lose much coolant.

try to disconect the bottom hose and drain it, the plug is located most of the times on the drivers side bottom corner of the radiratior.

Same deal, run water hose and cleaner in the overflow tank and just keep letting it flush until the water coming out of pitcock in bottom of radiator is clean.

Things you will need:
Radiator coolant mixture (get from garage)
Radiator flush fluid (also from garage)
Distilled water (Or if your me garden hose water ;) )

Take off the radiator cap when engine is COOL. Find the drain plug located in the bottom of the radiator (normaly hand tight) and let it drain out into a catch container. Put the drain plug back in, follow the instructions on the flush container topping the radiator back up. Let engine run as directed on bottle and then carefuly undo the radiator cap using a rag as not to burn yourself. Then remove the plug again and drain out the flush fluid. Then repeat the process with the radiator fluid as instructed on the bottle.