Hi, if you have power windows start by disconnecting your negative battery cable. Then you need to locate and remove the screws that hold your interior door handles in place (they may be hidden by snap in, or snap on clips). Once you remove the screws that hold the door handles, remove any wire connectors to the handles, if they're not power you will need a small hook (kinda like a knitting needle) to remove the window crank. A manual window crank is held in place by a clip on the base. Slide the hook behind the base and remove the clip. The door panel itself, is held on by snap in clips, and you will need a small pry bar to pull them from the door (try to get as close to, or directly under the clips to prevent them from tearing out of the door panel). Once the clips are removed from the door, pull the panel upward to remove it from the door.
Install in reverse.
SOURCE: i need to remove the rear door interior panel on
on the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.pull back the weather seal and you'll be able to get to the track
385 views
Usually answered in minutes!
The advice was well intentioned but did'nt help much, there were no scews or snap on clips, with a little patience and determination I figured it out myself. after you get the door lock knob off the whole panel just pops completely out.just lift and pull outward at the same time. Its basically held in by the male - female electrical connections. Thanks, Bill
×