How do you change a clutch cable on 97 saturn sc1?

when was the clutch last change ?
my saturn is a 1998 with over 300k and never had this happen but I have changed my clutch at 275k

easy way is one person pushes down on pedal and other bleeds out slave. Good luck

It sounds like the solenoid on the starter. The starter is mounted on the back of the engine, underneath the intake manifold. It is a bit tough to get to. I would check your cables, battery and starter cable connections for looseness or corrosion.

very hard to get to, shops sell them as pre-bled master and slave unit.

if you can give me model SC1,SC2,SL,SL1,SL2,SW1,SW2 and 8th digit of vin i can help you more

Transmission is not junk. You need to replace the valve body with a rebuilt one. The cause of reverse not working is because the booster valve cannot create sufficient pressure to get into reverse (reverse requires the most pressure). The booster valve is worn down and the valve body needs to be replaced, rebuilt is the way to go. This is from not changing the fluid and filter every 20,000 -- 30,000 miles to keep gunk from building up and wearing down the valve.

The transmission is fine, don't let anyone talk you into putting another one in, especially for thousands of dollars, NOT THE PROBLEM.

Vin "7" or '9"???if #4 is firing so is #1. they both fire at the same time. have you swapped the wire with number 4 or another cylinder? have you checked for a injector pulse on #1 fuel injector? Compression on #1 Cylinder?

sounds like you got a bad shift syncro for 3rd gear, its inside the trans,cuse ive never adjust shift cables on a s-series now matter what was done to the trans,and that cable controls more than just 3rd gear so its gotta be the syncro,,sorry,,,cheaper to get a used trans than to fix

my sc1 97 saturn dont work on reverse when is hot

Check the cable clips at the trans. Sometimes these clips come out and won't shift. Horseshoe clips that hold the cable housing.