Where is the crankshaft position sensor located on the 2001 dodge durango 8cyl. 4.7L 2wheel drive?

Question edited for clarity.
Question moved to model category.

In the link, videos as well

https://www.google.com/search?q=2001+dodge+stratus+rt+3.0+crankshaft+position+sensor+location

..

You posted twice (you have to refresh the page to see your post), so I amalgamated both into one.

There is a video here. You can also click on the images tab for pictures.

https://www.google.com/search?q=2002+dodge+durango+5.9+crankshaft+position+sensor+location

..

The 2001 Durango with the V8 is limited to 115 from the factory.

Its number two.

Without doing the tests and diagnostics I have no idea as to what the proboem might be. I will say the computer fail rate is very low for all cars.

For testing crank sensor,check the help link below:---How to test Crankshaft Position Sensor? http://fordrepairhelp.blogspot.in/2012/03/how-to-test-ford-focus-crankshaft.html
----------

• How to test Crankshaft Position CKP Sensor?

---------------
Crankshaft Position Sensor Operation?

----------------
Replace Camshaft position sensor and Crankshaft Position Sensor? http://technoanswers.blogspot.in/2012/06/2005-dodge-durango-replace-camshaft.html
----------
GMC Crankshaft Position (CKP) Sensor Replacing? http://schematicsdiagram.blogspot.com/2011/12/gmc-crankshaft-position-ckp-sensor.html

------------
These details will help.
Thanks.

4.7L
The Crankshaft Position Sensor (CKP) is mounted into the right-rear side of the engine block.

5.2L & 5.9L
The Crankshaft Position (CKP) sensor is located near the outer edge of the flywheel (starter ring gear).

3.9L, 5.2L & 5.9L

1. Remove right front tire and right front wheelhouse liner.
2. Disconnect crankshaft position sensor pigtail harness from main wiring harness.
3. Remove two sensor (recessed hex head) mounting bolts.
4. Remove sensor from engine.

4.7L

1. Disconnect CKP electrical connector at sensor.
2. Remove CKP mounting bolt.
3. Carefully twist sensor from cylinder block.
4. Remove sensor from vehicle.
5. Check condition of sensor O-ring.

CAMSHAFT POSITION SENSOR 2001 Dodge Truck RAM 1500 1/2 ton 2WD 5.9L SFI 8cyl The Camshaft Position Sensor is located: Under hood, center, upper engine area, rear of intake manifold, mounted in distributor

If this is helpful.Please leave ositive Feedback. Thanks, SnugglePants

It could be a couple differentthings, first I would check the EGR Valve, it could be sticking open/leaking. Or it could be IAC valve (idle air control) sticking or faulty. Or it could be the MAF sensor faulty or damaged.

u cannot change the emer shut off u would have to take it where their is an ase certifed personil to change that sorry.