SOURCE: 2001 Chevy impala had ignition switch replaced,
Turn the key to "on" and let the light flash. It should stop flashing after about ten to twenty minutes. Once the light is on steady, turn it off, then start the car. I usually put another battery on jumper cables attached to the cars battery so it does not run down and die before the system re-arms.
SOURCE: PUT IN NEW STEREO NOW CAR WON'T START & SECURITY LIGHT IS ON
i am in training for a mechanic and all you have to do is put a battery charger on it and leave the ignition on it needs to re learn the system
SOURCE: Replaced ignition switch 2003 chevy impala and car will not start
After you replace the ignition switch turn the key to start the car and release leave the key were it stops after trying to start wait 10 minutes until security light goes out turn key to full off position then repeat the above procedure two more times for a total of three on the 3rd attempt to start car wait for light to go out then turn key to full off positoion wait 10 seconds then try to start car body control module should learn new pass code and the car should start.
Big john, J@J Automotive
SOURCE: how do reset the security system on a 2002 chevy
Good morning, I am having a problem starting my 2000 chevy venture. I believe its the security system acting up, can anyone tell me how to reset the vechile's security system?
124 views
Usually answered in minutes!
When I drilled out my ignition my friend coded a key to it and it started you just stuck it in the big hole and the car started my alternator went out I changed it now my car won't start there is also a passkey 3 security system
×