Coud not inistialize the device - Cars & Trucks

Does not sound like a bearing problem...I suggest you check the spare..most vehicles with the air pressure devices have the in the spare also...Check your wheel lugs make sure they are tight..to check the bearing jack the vehicle up one wheel at a time and Check for play in the bearing..there should be zero play in and out up and down or side to side...if there is need to replace it..good luck..

coud be a sensor,have it checked out.possibly the ecm.









TIM....................

is the drag contstant if so coud be breaks or wheel bearings if only on breaking then your pads are welding to the discs if all the time then transmission or wheel bearings

can only be done with the dealer software ,you coud adjust the cable a bit though

coud be a belt slipping youmay need a new one

check the windscreen washer strainer it could be glogged up or it coud be a faulty windscreen motor pump.

5 spd? Only one gear? Possible blocking rings worn out.

it coud be 1 of 2 things could be housing gasket or front seal behind the engine pulley

The oil pressure sending unit may be the leak. Look at it again and see if the oil is coming from a small device that has a wire plugged to it. If so then it is the oil pressure sender. They are inexpensive and easy to replace. Just buy one unscrew the old one and screw the new one in snug do not over tighten. Remember to plug it back in.

a crossed wire somewhere