SOURCE: gear shift light out in 1997 Honda
remove console and inspect for sought after malfunctioning bulbs and replace and reinstall console .
SOURCE: Corolla: How do I replace the bulb under the gear shift console?
It's most likely the 12v 1.7w bulb located underneath the "prnd21" To get there: remove the the console piece just surrounding the black shift area piece- there are six tabs to undo, using a thin screwdriver(a piece of tape may help to not scratch the area) carefully pry and lift out that piece. Now, you'll see 4 clips(2 on left, 2 on right) on the black plastic shift piece, carefully unsnap these and lift up this piece. The bulb slides in and out, it DOES NOT twist. I used a needle nose pliers and a piece of one of those "jar openers" you get from real estate people(advertising..) There's not much room to get in there and get a grip on the bulb, but you can do it.
SOURCE: light bulb is burned out on gear shift console.
The center console needs to be removed, pull the shift plate plastic
cover off, remove two bolts inside the console storage box, remove the
phillips screws that are visible, the front center storage box also has
to be removed, the bulb is located on the left side of the shifter from
underneath.
Hope helped with this (remember rated this help) Good luck.
SOURCE: 2007 pontiac vibe gear shift light replacement.
On the 2004 Pontiac Vibe that I owned, I ended up taking it to the dealer. Perhaps this advice can avoid having you end up at the same place!
Remove the middle environmental control knob (fan blower speed, I think) by tugging on it until it comes off. Underneath you will find a single Phillips screw. Remove the screw and gently (so you don't mar it), pull at the plastic trim surrounding the environmental control area. It should pop out. You may also want to remove the two-prong AC outlet by prying it gently out with a small slotted screwdriver before attempting to pry out the trim panel.
After that panel is out of the way, you are ready to tackle the plastic trim surrounding the shift knob. Begin by removing the small holding compartment at the base of the shift knob. There is a single Philips screw holding the plastic piece to a supporting brace on the lower end. Four additional screws on the upper end are revealed by the removal of the environmental control trim piece as previously described.
Okay, from there, you're ready to gently pry loose the trim panel surrounding the shift knob.
The bulb can be located on the driver's side. It's a 'funny' looking bulb that is integrated into a two wire bundle. You may end up having to replace the bulb+wire bundle as a unit. The electrical connector is on the opposite side of the shift knob.
Good luck!
SOURCE: replace bulb on automatic gear shift console
If the shift console is on floor then look for bolts holding it down. Take out bolts and then you can maneuver console so you can see where light is plugged in and get the right light to replace it. It will probably be a small light which tend to cost a bit more, but at least you'll have the light back.
722 views
Usually answered in minutes!
×