The window crank is held in place by a locking clip. Remove the clip and pull the crank off the shaft. If the crank is stripped, just replace it. If the shaft is stripped, you have to replace the entire window regulator. See this post on how to remove a window crank.
http://ricksfreeautorepairadvice.com/remove-a-door-panel/
Remove door panel Ricks Free Auto Repair Advice
Remove door panel REmove trim panel...
SOURCE: Brake Light Problem -1997 Chevy Lumina
The ground wire in the trunk area, coming from the brake light harness, might have come off or really loose. Hope this will get your lights working again. Best wishes.
SOURCE: 1995 lumina cranks but will not start
Sounds like it has jumped timing, dont know which engine you have so could be chain or belt.
SOURCE: thermostat location
The thermostat is in a difficult position. Follow the upper radiator hose and it leads into the block under the throttle body.
Remove the air filter assembly and you'll c what is the exhaust manifold crossover pipe right in front of the thermostat housing.
NICE, it gives you very little room to remove the 2 bolts to the housing and once u remove those then you'll find you have the thermostat housing loose but because of that darn exhaust manifold crossover pipe u don't have enough room to take the thermostat housing out to change the stinking thermostat.
So from what you can see, you have to remove the heat shield which is cased around the exhaust manifold crossover pipe and if you still can't get enough room to remove the thermostat, (which you amy find out)then you'll have to remove the crossover pipe as well just to change the thermostat.
If you have to remove the crossover pipe then their are 2 bolts on both ends of the pipe leading into the manifolds. But then the tough parts done and once u switch the thermostat over and ATTENTION:remove any old gasket material and put a new gasket in it's place then installation is reverse of removal.
Good luck and hope this helps,
SOURCE: 1997 Chevy Lumina won't shift past 2nd
Have transmission service, oil and filtr. .Anywhere but aamco. sounds like valve body os sticking. do it soon.
73 views
Usually answered in minutes!
×