Where is the oil pump located on a i290 isuzu 2003 motor

SOURCE: how to change oil transmission isuzu rodeo 2003

There are two drain plugs on the bottom of the pan. remove the lower one to drain the trans fluid. To refill, use a pump and pump the fluid into the upper drain plug until it seeps out and re-install the plug, similar to refilling a manual trans.
Once this is done, Start the vehicle and run it for about 3 minutes, shifting through all gears (do not drive vehicle Remove the upper drain plug and let any excess fluid drain out. Done. This is as per Mitchell OnDemand.

SOURCE: 2003 5.3 liter oil pump

it should be located inside the oil pan.

SOURCE: Low beam headlight is out on 2008 i290

Hi

Most probably you are seeing a lot of clutter in the bonnet to put your hand in and change it right? The best way sometimes is to unbolt the headlamp , move it out change the bulb and back in. But another way would typically be to remove the battery (and battery holder plastic box) or air box (whichever is in the way) and then you should be able to access the headlamp cover from behind. Anyways in both cases you should find a metal clip holding the bulb. Unclip the bulb whilst making sure that you dont touch the new bulb with you hands while putting it in. Press its metal clip in place again. and be sure to mount the plastic cover at the back properly so no water goes in the headlamp if its raining.

It was nice to help you :)

Best Regards

SOURCE: How do I get the oil pan off to replace the oil

try these websites www.autozone.com and www.alldatadiy.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your SUV or stop by your local dealer in the parts department.and have them to print you out some diagrams.

SOURCE: Where is the oil pump located on a 2003 isuzu

Timing Cover Assembly



Oil Pump
Removal

1. Disconnect battery ground cable.
2. Drain engine oil.
3. Remove crankcase assembly.
4. Remove crankshaft pulley.
5. Remove timing belt.
6. Remove timing pulley from crankshaft.
7. Remove four fixing bolts from oil filter assembly.
8. Remove oil strainer fixing bolts, remove oil strainer assembly with O-ring.
9. Remove three bolts from oil pipe and O-ring.
10. Remove eight oil pump fixing bolts, then oil pump assembly.
11. Remove sealant from mounting surface of oil pump assembly, cylinder block and take care not to damage mounting surfaces of oil pump and cylinder block.