SOURCE: 1992 honda accord spark plugs and wire
chilton or haynes manual will give you all this and every thing else you need for your vehicle
SOURCE: Where & how to install thermostat in honda accord ex 1992
you need to follow the upper hose that lead from the radiator to the engine, there is two bolt that connect the thermostat housing to the block loosen the bolt using a 10 mm socket with ra-chet. Make sure that the engine is cool off before attempt to do this you will lose coolant but that's ok you will add the coolant when you finish replacing the thermostat. start the engine with the radiator cap off then add coolant slowly and cap it, then fill the reservoir up.
note the way you remove the thermostat that's the same way you will put the new one so pay attention when you remove the old one good luck.
SOURCE: 1992 Honda Accord slowly accelerates
Sounds like a bad timing belt. timing belt may need to be replaced,or igniting timing may be off. here is a digram if you need help with timing .http://www.2carpros.com/car_repair_information/tec_info/1992/honda/accord/1992_honda_accord_timing_belt_diagram_marks.htm Good luck and thanks for using FIX YA.
SOURCE: 1992 Honda Accord (LX) Instrument Cluster Replacement
Same as 2 dr, or a stick.
There are bezel screws that hold the plastic trim (pointing up towards the windshield), you nee to remove these 2 screws. The bottom section is clipped in. Tilt the steering wheel down as far as it will go.
Once you have the bezel off, there are 4 screws holding the cluster to the dash. Remove them and gently pull the cluster forward. Reach around (expect to get scraped knuckles) and unclip the speedo cable, and two large multipin connectors. Don't force anything.
Getting the cluster out after this point is a test of your patience. It only seems to come out one particular way.
27 views
Usually answered in minutes!
×