Torque specifications on pan for 03 Legacy Subaru

SOURCE: will 1999 subaru engine fit in 1997 subaru legacy?

Yes as long as the Motors are the same. You might need to have the computer out of doner car. Doors are suppose to fit 96 to 99.

SOURCE: oil and transmission pan bolt torque specs

124 inch lbs on oil pan...Transmission pan 13 ft lbs.

SOURCE: torque specs 1995 subaru

Did you want the torque converter mounting bolt torque? If so, it is 17 to 19 foot pounds.

Jeffrey Turcotte

• 8991 Answers
• Posted on Dec 22, 2010

SOURCE: i have a 99 subaru

sure. 2.5 liter engine, right? Thanks for using FixYa!

Secure the head in place with the mounting bolts. Coat each bolts with clean engine oil, and hand-tighten. Tighten the cylinder head bolts to the following specifications:

1. Step 1: all bolts to 22 ft. lbs. (29 Nm).
2. Step 2: all bolts to 51 ft. lbs. (69 Nm).
3. Step 3: loosen all bolts by 180 degrees, then loosen an additional 180 degrees.
4. Step 4: bolts 1 and 2 to 25 ft. lbs. (24 Nm).
5. Step 5: bolts 3, 4, 5 and 6 to 11 ft. lbs. (15 Nm).
6. Step 6: all bolts plus 80-90 degrees.
7. Step 7: All bolts plus 80-90 degrees.

SOURCE: I have subaru b4 legacy

hi i would invest in an electronic boost controller, they remove the dead spot in the revs before the big turbo winds in, they are worth a few hundred dollars but are well worth the money. You also have the option of turning up the boost safely a few psi with these but you will love the difference without the dead spot it will seem like a new car to drive. If you do that and want more still i would get a turbo upgrade, ecu upgrade, fuel pump upgrade etc do all that you can before going with the expensive motor rebuild