We only have one key fob for 05 chrysler 300 has one working.key fob. We bought 2 new ones on ebay and had then cut. How can we get them programmed without going to the dealer

Raygin

• 322 Answers
• Posted on Apr 03, 2009

SOURCE: 2003 Jaguar S-Type, programming a key fob

The switchblade key would need to be compatable with your ignition switch barrel. Only normally available from jag dealers who check the Jag owners register before supplying you a replacement.
The older type seperate fobs could be programmed by switching the ignition on and off 8 times (allowing all functions to settle) and on the 9th switch on - press a button on each fob and then switch off. to test use a good fob to lock the car then try the reprogammed fob to unlock/lock. Sometimes this works first time - sometimes needs a couple of tries.

SOURCE: Programming a key fob

you will need the dealership diagnostic tool to program the remote

SOURCE: 2001 Santa Fe Key fob Programming

change the batteries then start the car and close it and press the key it should work

Harvey N Tawatao

• 3854 Answers
• Posted on Dec 13, 2009

SOURCE: programing instructions for buick 2006 lacrossekeyless remote fob

Transmitter ProgrammingImportant: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.

1. Install a scan tool.
2. Use the scan tool in order to access programming: Vehicle Control System/Computer Integrating System/Module Setup/BCM/Program Key Fobs.
3. Press the START soft key on the scan tool. Important: The scan tool must stay connected until all of the transmitters are programmed.
   
4. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of 5-10 seconds, the scan tool will indicate that the transmitter is programmed.
5. Repeat the previous step in order to program up to 4 transmitters.
6. Remove the scan tool.
7. Operate the transmitter functions in order to verify correct system operation.

SOURCE: transponder chip in key fob

This will all depend upon what country you are in, and if the vehicle even has the need for the chip to be programmed at all.

When you put a proper key in the ignition, is there a antitheft logo that cycles with the other indicators?

VW antitheft indicator in the USA often looks like a car with a key under it

In the USA, thought the keys have a MEGAMOS RFID chip, no system was active until 2000, and on some models, not until 2002

A system requires a VIRGIN chip. Once the chip is programmed to a car, the chip is locked to that car. Some new software can unlock and refresh some chips, but not 100%

I had a client come in TODAY with a 2003 Passat, and an EBAY flip key.... I wasted a half hour programming time..... but I carry the lower half of remote, which hold the blade and the chip, so was able to fix client up, when EBAY failed.

If this was helpful, please post a nice review for City Lock in Boulder Colorado listings on Google Maps, Yahoo etc. This listing will link you to my website as well. On my website are resources for finding a legitimate locksmith near you. Be sure you are hiring a REAL locksmith!

Thank You

Jeff