I have a 2008 Chrysler Sebring and my headlights and the blinkers in the front quit working and so did the horn

SOURCE: blinker problem

I would suggest an internally shorted multifunction switch. It should not be very expensive at a dealer and really easy to replace.
MULTI-FUNCTION SWITCH REMOVAL

1. Disconnect battery negative cable.
2. Remove the upper steering column cover. Refer to steering column cover removal procedures below.
3. Remove multi-function switch mounting screws Multi-Function Switch
4. Disconnect wire connectors. Lift the switch straight up to remove.

1. Tighten multi-function switch to column retaining screws to 2.3 N·m (20 in. lbs.) torque.
2. Tighten steering column cover retaining screws to 2 N·m (17 in. lbs.) torque.

SOURCE: Replacing headlight in 1996 Chrysler Sebring JXI

piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

SOURCE: the headlights and fog lights,horn,blinkers,wipers,a/c,heater,and

pull the hazard switch out of your dash and replace the hazard fuse, it's about $25- $30 from the VW parts department. It took me a lot of time and money for such a simple fix.

SOURCE: replacing headlight bulbs on a 2006 chrysler sebring

Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.

SOURCE: I HAVE A 2005 CHRYSLER SEBRING AND DOME LIGHT,RADIO ALL POWER LOCKS HAVE QUIT WORKING

me too! - looking at fuse #5 red 10 Amp one but has black thing on it.

Can't get if off..

Have read the manual is wrong and to use panel on side of fuse box for fuse locations...