Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try
SOURCE: Anti-theft system stuck triggered
Doing roadside assistance I have ran into this problem several times and if you look in your owners manual it will tell you how to reset it. Some of the cars you have to wait up to 10 min. with the key in the ignition and try again. The light will go out. READ carefully our owners manual.
Hope this helped....Kevin
SOURCE: 2006 mercury mariner. stupid tail light assembly.
they are hard to take off sometimes, you are doing it right just keep willing it it will come off, there is 2 gromits that hold it into place might have a little dirt into the plunger.
SOURCE: 1993 lincoln towncar sunroof switch
I know this is an old blog but some people may still find it helpful. There are 4 wires in the roof window switch hooked up to 2 smaller harnesses that have 2 wires each.
Remove the switch and use only the metal contacts in the harnesses. One should use a light tester to confirm which one is the ground and live. this is how it turned out for my car.
One harness has a light blue wire with a black stripe, and a black wire. the blue one is live, the black one is ground.
The other harness has a red wire and a darker blue wire (silly ford) these are the motor connect and return wires.
You must hook up thhooked to (example, if the live wire was connected to blue motor wire and the ground wire was connected to red motor wire and it opened it, that would mean you would want to put the live wire to the red motor wire and the ground wire to the blue motor wire)
When doing these wire connections, it is advised that you have the ignition turned off. Once you make all the connections properly, you can turn on the ignition and if done correctly, the roof window will move. Once it is closed, remove the wires frome the harnesses and LEAVE THE ROOF WINDOW ALONE UNTIL YOU HAVE A NEW SWITCH.
e power (Live, light blue) wire to a motor wire. You must then run another wire from the other motor wire. To complete this circuit there is only one place that this last wire can go and it is to the ground. once this is connected the roof should either open more or close.
To reverse the operation of the roof, simply reverse the position of the live and ground wires in respect to which motor wires they are
SOURCE: 2006 Mercury Mariner - sticky gas pedal
I have a 2005 Mariner with the same problem. Always when the weather drops
SOURCE: how to I change the right tailight on my 2006
Open the liftgate and remove the 2 screws holding the lamp. Now grab the lamp and pull straight back to dislodge the spring clips. Then twist the sockets to remove the bulbs.
82 views
Usually answered in minutes!
×