My audi a4 leaking through the front back to passenger side

SOURCE: audi a4 front lights

if you mean the complete light you will have to remove front bumper then you will get to the bottom bolts that hold the headlamp in.....

joecoolvette

• 5660 Answers
• Posted on May 16, 2009

SOURCE: Repair shop can't find A/C pressure connections Audi 96 A4

The 1996 Audi A4 only has a High side refrigerant port. Right where you found it. Right side of radiator.
(Not to insult your intelligence. The passenger side of the car is the right side)

Look for the refrigerant lines going to the exchanger.
With this single port, you must evacuate the entire system, and replace the refrigerant with the proper amount.
(Obviously you can't refrigerant from cans, to the high side)

Your competent auto shop will have an evacuator, and charts to show the proper amount of refrigerant.

SOURCE: door panel

Here's how:

First, take out the two screws at the top of the door panel, screwed into the top corners and pointing toward the middle of the door panel.

Second, inside the door pull (where you pull the door shut) is one screw pointed backward - remove that. Then force the inside "lining" of that pull downward and remove it.

Third, remove the screws you have just uncovered (two on the front door, one on the rear door).

That's it - just lift the panel upward and it'll be off.

SOURCE: Audi A4

Not sure if they've changed it but this is what i do for my 99 a4

First remove the screw in the handle pull, it should be next to where your fingers go.
Pull down on the black piece of plastic and remove the screw form the door
Then remove the screws on either end of the door, one near the door jam on top and one near the other side, same place.
Finally pull up then out and the door panel should come out

Hope that helps

SOURCE: 2004 Audi A4 headlight replacement

you have to loosen the whole headlight assembly to open the covers behind the lights to actually get to the bulbs. 4 screws, 2 are on the top of the assembly(phillips screws) the other two are hex and attach the bottom of the assembly to the car. somewhat difficult to see but look behind the assembly and down into the compartment and loosen the screws(they don't fully come out) just enough to pull the assembly out. open the black cover behind he low bean and there is the bulb