SOURCE: driver side power window stopped working
The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps
SOURCE: replacing headlight bulbs on a 2006 chrysler sebring
Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.
SOURCE: Scan tool will not erase code # P-0601/2001 chrysler sebring 2.7
Sounds like a bad PCM.A dealer may be able to reflash the thing but not certain.Do a web search for the above code and you'll get all kinds of info. Good Luck
SOURCE: Where is the starter located on a 1998 chrysler sebring coupe
Follow the +cable from the battery. The starter is on the other end.
SOURCE: The horn on my 2006 sebring is going out. Is this a major fix?
It is located behind the right headlight assembly, remove that, one mounting bolt, and wiring harness, and it's out.
If you need anything else, let me know.
115 views
Usually answered in minutes!
×