Where is the battery located on a 2008 dodge avenger axt

SOURCE: Battery changing

Ok, trust me on this one, take the drivers side tire off and remove the forward inner fender panel. If you try it without removing the tire, it is just a royal pain.

SOURCE: where is the battery in a 2008 dodge avenger

It is in the drivers side fender well in front of the tire, it is mounted to the front frame rail. You have to remove the plastic fender lining to get to it.

SOURCE: Brake Fluid for 2008 Avenger

it's DOT 4 or DOT 5 check with your manual and sometimes it's even in the fluid fill cap.

Testimonial: "Quick response, guided me in the right direction. Thanks!"

SOURCE: 2008 dodge avenger spark plug location and socket size.

• 2008+ Dodge Avenger 2.4L 4cyl.
• Remove plastic cover on top of engine, just pull on each corner for it is friction fit.
• Once removed you will see 4 black spark plug covers with one hex type screw holding each.
• Remove Hex screw and place aside, pull upward to remove plug boot from plug.
• To remove the plug, use a 5/8 socket with a 6" extension. Once plug has been turned out all the way and you cannot get the plug up and out of the hole, just press the plug boot back on the plug and pull it back up.
• Gap and replace 4 plugs with the same or equavalent type,. Drop plug down the hole and use socket to align and tighten until just snug, then torque to manufactures specifications.

SOURCE: how I take the battery off my car?2008 Dodge

On a Dodge Avenger from 2008 the battery is behind the driver side wheel. You have to take the wheel off and then remove the plastic fender and the battery is right there just behind the front light. Here's how to replace it: 1. Block your tires, jack up the left side of your car and place a jack stand under your car. Luckily for me I was at home and had access to my stand. If out and about you may not have access to a stand, make sure your jack is in tip top shape.
2. Remove your tire. You possibly could do it without removing the tire, but you would be making your life so much more difficult. 3. Now you have accessed the wheel well and must remove the fender shield. There are two socket head bolts on the outside which are 9/32." Next remove seven push-in style retainers. You must pry them out carefully so that you can reuse them. 4. You can now for the first time see your battery, but you are not quite there yet. There are two retaining systems in place. First is a cross way bar which is removed using the 13MM Socket. Next you must remove the actual battery restraint. This is held on with another bolt that is also 13MM. 5. Remove the battery cables using the 10mm socket. The red cable comes of fairly easy, but the black cable is a bit of a stretch. If you have short arms you may need some help here. Also I could not get the socket onto the black cable, so I needed to use the open ended wrench. 6. Finally you battery is free. Pull it out carefully and place it aside. Now slide in your new battery. 7. Inspect your cables. Make sure that everything is in good shape and that you have a solid connection before you put everything back into place. 8. Replace everything in reverse order.