SOURCE: volvo s60 abs systems
it is most likely that the abs module is faulty,, if the fault codes are read and it shows a fault with the right rear sensor then the module is faulty,,they usually go wrong at about 110//140k
SOURCE: Replace timing belt on Volvo S60
There is no room for error...... Zero clearance. If off one tooth it can and will bend valves. if you are one that just feels the need to get alittle dirty or just can't pay for the service, then get out your Haynes out and turn to .....Tune up, and look at replacing timming belt. Get a cam gear tool that locks them into place so as that they will not move when u have them lined up. make sure they are lined up with marks as said in book. then make sure crank as well as all marks are lined up acordingly. make sure belt marks are lined up with everything. i would reccomend using a volvo belt though cause it will have all the marks on it.However other company's make good quality belts also at a fraction of the price. So it is really up to you.
Good thing when doing timming belt is to also change out your timming belt tensioner. YES do this it will save you a engine in the long run. it is a moving part that will go bad, it will freeze up and snap timming belt. rip out teeth in thebelt and bend valves. So as a gen rule...When you change timming belt, Change belt tensioner at same time since you cant just change tensioner without changing or getting timming belt off. Remember to use your HAYNES. It is your friend and will save you money in the long run. Good luck... Hope this helps you.
SOURCE: 2001 Volvo S60 2.4 won't start
try to start your car with the valet key instead of master should start right up problem is master key.
SOURCE: CODE 042 ON A VOLVO S60
Brake lights and cruise control are not set properly.
Easy check - are your brake lights coming on with just the usual light touch of the pedal? If not, then the microswitch that senses that your foot is on the brake needs to be adjusted or replaced.
SOURCE: I have a 2004 Volvo S60. How can I clear the
Close all doors.Turn ignition key to position 1.PRESS AND HOLD trip reset button,immediately turn ignition to position2,keep trip button held untill trip is reset to 0.A yellow warning light will show when it is time to release trip button.Release within 4seconds ,a bleep will be confirm reset.Before you start reset, do not reset trip,If trip has been reset to 0,turn ignition to position 2 hold reset for 10- 15 secs untill previous reading is shown,then start reset.
111 views
Usually answered in minutes!
×