SOURCE: torque specifications for 1998 ford ranger
Okay...here is a list since no motor size:
2.5L----- 56-64
3.0L----- 56-64
4.0L----- 59
5.0L----- 75-85
All in ft lbs.......this is for the flywheel.
SOURCE: i need the torque specs for a ford 300 inline 6
Tighten all bolts to 10 Lbs, then 20 Lbs, then 35 Lbs.
That should be fine for the 6 cylinder flywheel.
SOURCE: NEW CLUTCH SLIPPING ON 2004 V6 HOLDEN RODEO
did you bleed the hydralic clutch system on this vehicle? = air in system or not bleed properly.
most of the flywheels for this model were not to be machined...... however it is ok to machine these only slightly but you must machine the surface the clutch plate contacts with the same amount as the outer raised section the pressure plate bolts to.
new flywheels have painted stamped writing saying do not machine...so if hydralic system is ok find out about flywheel.
also may pay to check clamping force of pressure plate most clutch places can do this or some workshops that is if fingers on pressure plate are all at the same height, not broken or cracked..
778 views
Usually answered in minutes!
×