SOURCE: remove fuel lines from tank (quick disconnect) 2006 f-250 diesel
yes there are 2 lines the feed line and the return line
SOURCE: Disconnect fuel lines from fuel tank
There are two types of connectors on these lines. Either brightly colored quick-connects which do not require tools, (Just squeeze the tabs together). Or black quick connects which must be pushed back to remove line.
SOURCE: how to adjust halogen headlights on bmw z4
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
SOURCE: need a 2003 BMW, z4, 2.5, water pump diagram
CLICK on the following LINK. It has the Belt Diagram you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/2003/make/bmw/model/z4/2003_bmw_z4_drive_belt_routing_diagram.htm
Testimonial: "I thank you very much for your expertise, will install the belts this week end. Poorman, thanks you again. Doing it my self is saving me alot of money"
SOURCE: Where is the fuel filter located on a 2006 bmw z4?
Hi, On the E85, MY03 - 09 a seperate fuel filter is absent. Unlike the E36/E46 which has an inline filter and is reaplceable as part of the maintenance items, the E85 does not have this 'feature'. The fuel filter is an integral part of the intank fuel pump [ which i believe is like the strainer.
In order to change the ff the entire pump assembly has to be replaced. On the safer side this is one of those items best left to be done by the dealer.
Regards Sean/elytics
The fuel filter is serviced only as part of the left fuel level sensor assembly in the fuel tank
1. Remove rear seat bench
2. Fold carpet forwards
3. Fold back rubber mat
4. Remove the nuts and fold back metal cover
5. Disconnect electrical connector
6. Release and disconnect fuel feed and return lines
CAUTION: The fuel gauge must roughly indicate zero before the left tank opening is opened. Large quantities of fuel may emerge upon opening. If necessary, keep the left tank opening closed and feed an extraction hose through the right service opening to the left tank half and drain the fuel out of the left tank area before proceeding.
7. Release the screw cap
8. Carefully raise fuel level sensor until sensor flange emerges.
CAUTION: Risk of breakage! When raising sensor unit, do not pull excessively on connecting piece of fuel return line.
9. Disconnect line to fuel filter
10. Disconnect suction jet pump from fuel filter (Press catch downwards to detatch suction jet pump)
11. Remove left sensor unit from the tank.
12. Reverse order to install
120 views
Usually answered in minutes!
×