2006 nissan maxima ecm location - Nissan Cars & Trucks

Could be Child safety lock help prevent the rear doors from being opened accidentally. The child safety lock levers are located on the edge of the rear doors.

Up above the brake pedal. Diagram in the answers

https://www.fixya.com/cars/t27114019-body_control_module_located_in_2004

https://www.google.com/search?q=2006+Nissan+Maxima%2C+BCM+Location

..

The slip light illuminates when a traction control component fails or sends incorrect info to ecm. Normally problem is at wheel speed sensor, DO NOT REPLACE SENSOR UNLESS PROPERLY DIAGNOSED AS DEFECTIVE. FIRST all reason normally is due to gathering of debris at sensor , I would raise front wheels and support vehicle with jack stands (SAFETY FIRST) Remove wheels and locate wheel sensor and clean as needed. and see if this corrects problem. if problem still persist. then check for stored dtcs and start from there


I’m happy to assist further over the phone at https://www.6ya.com/expert/james_9ddabbbc483e2add

The iac is located on your tb. It has a brown and a green connector going into it. Its the green one. The brown one is for throttle position. Just know once u remove it. Only nissan can program it back to factory settings. Unless u are good with a multimeter

The computer near the battery is the ecm. It will have three connectors going to it.

see the next image:

God bless you

U1000 - CAN Communication Line Signal Malfunction

Causes:
- Harness or connectors (CAN communication line is open or shorted)
- Faulty Engine Control Module (ECM)

Solutions:
- Poor harness ground connection

There is a service bulletin for the following Nissan models with U1000 code:

2002-2006 Nissan Maxima
2004-2006 Nissan Titan
2004-2006 Nissan Armada
2002-2006 Nissan Sentra
2005-2006 Nissan Frontier
2002-2006 Nissan Altima
2005-2006 Nissan Xterra
2005-2006 Nissan Pathfinder
2004-2006 Nissan Quest
2003-2006 Nissan 350Z
2003-2006 Nissan Murano

The service bulletin suggest cleaning engine and body harness ground connection to repair problem.

2002 Nissan/Datsun Maxima 3.5L SFI DOHC 6cyl



Fig. View of thermostat and components




Fig. View of thermostat and components-2002-2006 Maxima

1. Before servicing the vehicle, refer to the Precautions Section.
2. Drain the cooling system.
3. Remove or disconnect the following:
   
   Negative battery cable If equipped, engine cover On 2002-2006 Maxima, air duct and air cleaner case On 2002-2006 Maxima, drive belts Water drain plug on water pump side of cylinder block Lower radiator hose Water inlet and thermostat assembly
   
4. To install, reverse removal procedure
5. Install thermostat with jiggle valve facing upward.
6. Run engine and check for leaks

Good luck (remember rated this help).

The ecm should be under the radio at the front of the console.

It will not work at all. 1992 maxima is a J30 body style. 1998 Maxima is a A32 model. Totaly different cars.