DIY servicing
The Holden and Chevrolet Captiva is the same vehicle. Above is a link to a UK forum on the vehicle. Go there and read. If this does not provide you a specific enough answer, ask your question there for a final answer.
Good luck.
Semper Fi,
Z
SOURCE: i was wondering where the fuel filter in my 1991
LHF corner of the fuel tank under the car - roughly under the back seat.
SOURCE: need directions to fit towbar
there is a standard tow bar and a 2000kg for genuine tow bars
you need to remove both tail lights,the bumper bar and reinforcement bracket, spare wheel and exhaust hangars on rear mufflers, remove the tie down bracket on LHS chassis rail(dont need this or the bolts that hold it on), so you can then bolt in place either of the 2 tow bars.
genuine wiring patch harness for trailer plug is my suggestion since its plug straight into vehicle and interfaces with vehicle, goes in right hand rear compartment remove lid then remove box, interface connector for trailer harness is there.
instructions can be printed out from dealers if you ask
some new kits dont come with instructions in kits because information is on dealer computers
there is a template to print out to cut hole in bumper bar for tounge area of tow bar, uses centre square dimple in bar but its a bit wider.
SOURCE: Location of fuel filter Holden barina tk 2006
Under the rear passenger seat, you will find a plastic hatch, it is in the fuel pump.
Not serviceable item. I did take my pump apart and clean the fine filter. The only way to change the filter is to get a new fuel pump.
SOURCE: fuel filter location on renault laguna 1.5dci
most cars have them at back under follow fuel lines from tank.
SOURCE: How to fit towbar to holden captiva
As fitting a tow bar to the vehicle requires a modification plate to be fitted to keep it legal I suggest that you have the job done by accredited tow bar fitting specialists. They have the correct wiring loom and the plate to fix to the vehicle for the modification
3,051 views
Usually answered in minutes!
×