SOURCE: driver side power window stopped working
The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps
SOURCE: replacing headlight bulbs on a 2006 chrysler sebring
Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.
SOURCE: i need the firing order on a 1999 chrysler sebring
153624 on a six cylinder. This should be in cast on the intake manifold. To locate what tower to use on the cap, do this. pull the #1 plug. Bring it to tdc on the compression stroke. Now chk out where the rotor is pointing and that's the tower for #1. Good Luck -Ned-
SOURCE: oil sending unit on 2004 chrysler sebring V6
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
SOURCE: firing order for a 98 Chrysler SeBring LXI V-6
135
-------
246
Testimonial: "Thank you for your help!"
399 views
Usually answered in minutes!
×