I can't seem to open the house assembly for my brake light so I can replace the brake light(one that glows brighter when you put on the brakes) on my 2009 matrix driver side.

SOURCE: 2002 Camry Brake lights

sounds like you nee a couple of new globes

SOURCE: How do I replace the Rear Brake light bulb of 2001 Toyota Sienna?

I have a 2001 Sienna and have had to replace most of my tail light bulbs.

The bulbs that are mounted in the fender (wrap arounds) have acess panels in the van's interior that easily pop out and expose the back of the light assembly.

However, the bulbs that are found in the lift gate are a different matter. You have to remove the whole interior panel to the lift gate to expose the light assemblies. Go to your auto parts store and get a tool to help pop out the plastic retainers from the lift gates metal frame. Don't force the retainers out. Go slowly and gently so that you don't damage the interior panel. If you are really gentle you might even get to reuse the retainers.

Good luck!

SOURCE: 2009 corolla warning light (!)

I have the same problem the car was bought in March I could not possibly need new brakes this early and I checked the brake fluid and it is full to the max line. What do you mean check the bulbs how do I go about that?

SOURCE: 2003 Toyota Highlander.The brake light on the

Replace the right rear brake lamp. The bulb possible use two filaments one for brake and tail light. One burnt out filament in one bulb.

SOURCE: my tail/brake lights wont blink

COULD HAVE FAULTY BRAKE LIGHT SWITCH OR BAD GROUND WIRE AT BRAKE LIGHTS AND TURN SIGNAL LIGHTS.