II'm having trouble removing the bolts on oldsmobile 1999 cutlass oldsmobile

SOURCE: 1989 cutlass oldsmobile with tilt steering wheel ?

remove column trim, insert ket turn to on position, and push the pin in at the underside of the steering column pull straight out please rate -jeff

SOURCE: 1999 olds cutlass glove box removal

you need to remove all the screws on the bottom of the glove box on the outside, then on the inside remove all the screws too. and then pull it out. sometimes some glove boxes have stoppers on the edge of the door inside and you have to pry on them to pull the stoppers in front of the side of the glove box so you can remove it entirely from the dash.

SOURCE: Need to replace intake gasket 1989 Oldsmobile Cutlass Ciera

I am doing intake gaskets right now on an expedition and you have to look carefully around and take your time and you will find what is holding you up from taking it out because nowhere in the book does it state you had to take the two bolts out for the thermastat housing on the expedition that I am working on you can also go to auto zone and they can give you a diagram because you will need the torque specs anyways

SOURCE: 1991 oldsmobile cutlass Location of starter

Follow the red wire from the battery towards the firewall. It will end at the starter.

SOURCE: 1999 Oldsmobile Cutlass Cigarette Lighter Fuse

Under the hood directly in front of the driver is a covered fuse block. Remove the cover and the fuse is #34.